inside the appliance. This will damage the appliance and will void any claim
to the warranty.
5. Add 2–3 drops of your favourite liquid fragrance directly into the water. It is
not necessary to mix them as the ultrasonic membrane (8) does this for you.
Only use fragrances, aromas or essential oils that do NOT contain alcohol.
6. Close the lid (10) again.
7. Then switch Lucy on by pressing the on/off button (4).
8. If you would like to top the water up, switch off the appliance and disconnect
the USB cable if it is connected to the appliance (1 + 2). Remove the lid (10)
and fill the water up to the maximum mark.
9. If you are disturbed by the brightness of the illuminated mist (in the bedroom,
for example), you can reduce the brightness of the LEDs by pressing the dim-
mer button (5). You can choose between three different modes:
• Normal mode (switched on as standard)
• Dimmed mode (press once)
• Light-off mode (press twice)
You can return to normal mode by re-pressing the dimmer button (5).
10. On the back of the bottom part above the connection for the USB cable (2),
you will find the status display for the battery (3):
• Normal operation with fully charged battery: LED is not illuminated
• Battery level 10 % or lower: LED flashes
• Battery is charging: LED is illuminated constantly
When the device is fully charged, the LED will go out. You can now disconnect
the USB cable and use the device in battery mode (for up to 7 hours).