Slime 40065 Manual Del Usuario página 3

WALL MOUNTING / STORAGE INSTRUCTIONS*
Your inflator has built-in features for conveniently wall mounting the unit for storage.
Use the included hardware to wall-mount the unit. Take extra care to ensure there
is no wiring, plumbing, or other objects located within the wall behind your chosen
mounting location. Manufacturer is not responsible for any damage or losses incurred
from complications in wall-mounting.
For Drywall mounting:
1. Use the template below to mark mounting locations on wall 3 1/16" apart.
2. Using 1/4" drill bit, drill holes at the marked locations.
3. Using a hammer, tap in the wall anchors until flush with the wall
4. Using a screwdriver or screw gun, install the screws into the wall anchors, leaving
approximately 3/8" protruding from the wall.
5. Hang the inflator on the screws using the recesses located on the back of the
inflator.
*NOTE: Wall mount is for storage only. Remove inflator from wall mount and place on
a hard clean surface before operating
⁄
3 "
1
16