Care And Cleaning; Internal Cleaning; Cleaning Of The Toe Kick Cover And Condenser - Bertazzoni FRZ 5UB TT Serie Manual Del Usuario

10. CARE AND CLEANING

10.1 Care and Cleaning
To clean the parts made of steel use a microfiber
cloth and the sponge provided in the kit with the
appliance. Always use the cloth and sponge in the
direction of the steel's satin finish.
Every now and then, to polish the steel, wipe with a
slightly damp microfiber cloth.
Do not use the sponge on aluminium parts, such as
the handles and the profiles of the glass shelves.
You should use special care to keep the ventilation
openings in the appliance or in the cabinet that
houses it free of obstructions.
Carefully follow the detailed directions
that can be found in the provided kit and
never use abrasive or metallic products
which could scratch and damage the satin
finishing on the appliance permanently.
Before performing any sort of cleaning,
disconnect the appliance from the electrical
power supply.
Make sure you do not damage the refrigerant
circuit in any way.
Warning
Do not use chlorine-based detergents or
cleaning agents.

10.2 Internal cleaning

Clean the internal and removable parts by washing
them with a solution of lukewarm water, a small
amount of dishwashing detergent.
Rinse and dry right away.
Do not use mechanical devices or other methods to
speed up defrosting.
Warning
Do not use water on the electrical parts,
lights and control panel.
Warning
The use of chlorine-based detergents or
similar that contains it should be avoided
(bleach, hypochlorite, etc).
Do not bring cold glass parts into contact with
boiling water.
Do not wash any parts of the appliance in
a dishwashing machine since this could
damage or irreparably deform the parts.
10.3 Cleaning of the toe kick cover, filter
and condenser.
It is recommended to perform the following cleaning
steps very 6 months. An audio and visual message
on the display will serve as a reminder.
It is possible to disable the warning signal and see
the time left before the next cleaning has to be done.
Behind the frontal toe kick cover there is the
condenser.
To clean it use a vacuum cleaner with a soft brush
attachment at maximum power, sweeping it along
the vent slits. In case of a significant dust build up,
the toe kick cover can be removed to allow a more
accurate cleaning of the filter.
On the mantenience settings,
installation of the unit and after it has been turned
on, you can set the condenser cleaning warning.
In the case the warning sign is enabled, there
will be an audible signal every 6 months,
alerting that it is time to clean the condenser.
After cleaning it, touch the reset icon in order
to reactivate the warning signal in 6 months.
If you do not want
alert for the condenser, touch the Off icon.
Maintenance Service
after the
Info System
the cleaning signal
31
EN