Product Familiarisation; Unpacking Your Tool; Before Use - Varan SPT-15103 Manual De Utilización

Do not restart the cutting operation in the workpiece. Check the cutting accessory for damage and
c)
allow the wheel to reach full speed before carefully re-entering the cut. The wheel may bind, walk up or
kickback if the power tool is restarted in the workpiece.
Support panels or any oversized workpiece to minimise the risk of wheel pinching and kickback. Large
d)
workpieces tend to sag under their own weight. Supports must be placed under the workpiece near the
line of cut and near the edge of the workpiece on both sides of the wheel
Use extra caution when making a 'pocket cut' into existing walls or other blind areas. The protruding
e)
wheel may cut gas or water pipes, electrical wiring or objects that can cause kickback.

PRODUCT FAMILIARISATION

UNPACKING YOUR TOOL

• Carefully unpack and inspect your tool. Fully familiarise yourself with all its features and
functions
• Ensure that all parts of the tool are present and in good condition. If any parts are missing or
damaged, have such parts replaced before attempting to use this tool

Before Use

Fitting the quick connector
Note: This tool is supplied with two different male airline quick connectors: EQ-4 – commonly used in
Europe EN-6 – mainly used in the UK
EQ-4 Europe
• Please choose the connector that is compatible with the airline system you are using, and install
as outlined below:
Apply some PTFE tape (not included) to the screw threads of the Quick Connector (10). This
1.
will help to maintain an air-tight seal
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
1 Body / Handle
2 Guard
3 Spindle
4 Bolt & Washer
5 Cutting Disc (not supplied)
6 5mm Hex Key
7 14mm Spanner
8 Safety Catch
9 Speed Control
10 Quick Connector
EN-6 UK
T: 00352/26908036 – F: 00352/26908040
SPT-15103
SPT-15105