Charging The Device - Konix HAKA GO Manual Del Usuario

A
PAIRING THE DEVICE
Switch on the device. If the device has not been previously paired, it enters the
pairing mode. The blue and red indicator lights flash. If the device has been pre-
viously paired with another device, make sure that the previously paired device is
switched off.
Activate the Bluetooth function on your phone or Bluetooth devices and set it to
search for Bluetooth devices.
Select «KX-HP-HAKA-GO» from the list of found devices.
If the Bluetooth connection is successful, the blue light flashes once every 3 se-
conds. The device will automatically connect to the previous paired device if it is
within range.

CHARGING THE DEVICE

Make sure the headphone is powered off, then connect the charging cable to
the USB interface of your PC/ Laptop or any other USB power outlet (1A output
maximum). The LED light will be red during the charging process, and it will turn
off when the charge is completed. Please fully charge the headphone before you
use it the first time.
2. Switch the Power button to «ON», you will hear « Power on» then go into pairing
mode automatically. Open your Bluetooth equipment and find the model of « KX-
HP-HAKA-GO» in your list, then click for pairing until you hear «Paired".
3. Switch the Power button to «OFF», you will hear «Power off»
SAFETY
To reduce risk of electric shock, this product should only be opened by an autho-
rized technician when service ls required.
Disconnect the product from the mains and other equipment if a problem should
occur.
Read the manual carefully before use. Keep the manual for future reference.
Only use the device for its intended purpose. Do not use the device if any part is
damaged or defective
4