Adjustment Procedure - KNOVA KN BTS-10W Manual De Instrucciones

ADJUSTMENTS

ADJUSTMENT PROCEDURE

1. Turn saw switch OFF and remove plug from the power
source.
2. Remove blade guard and splitter assembly, miter gauge and
rip fence.
3. Using the 10 mm hex wrench, slightly loosen the two middle
blade alignment rod strap bolts (1) and two rear blade align-
ment rod strap bolts (2) located on the underside of the saw
table (see Fig. 16).
4. While standing at the rear of the saw, use a medium size
slotted screwdriver and gently pry the rear of the blade align-
ment rod to the LEFT or RIGHT. Using the framing square,
simultaneously measure the distance at the front and rear of
the blade to an edge of a miter slot. When the distances are
within 1/64 in. or closer, tighten both rear blade alignment rod
strap bolts (2) while holding the rod firmly in place.
NOTE:
The blade alignment rod will only move slightly.
5. If alignment is not achieved by rear adjustment, loosen the
two front blade alignment rod strap bolts (3).
6. While standing at the front of the saw, use a medium size
slotted screwdriver and gently pry the front of the blade align-
ment rod to the RIGHT or LEFT. Simultaneously measure the
distance at the front and rear of the blade to an edge of a miter
slot. When the distances are with in 1/64 in. or closer, tighten
both front blade alignment rod strap bolts (3) while holding
the rod firmly in place. NOTE: The blade alignment rod will
only move slightly.
7. Tighten both middle blade alignment rod strap bolts (1).
NOTE: Recheck to make sure all six bolts are properly tight-
ened and that the distance from the front and rear of the blade
to the miter gauge groove are within 1/64th of an inch from
one another.
8. Reinstall blade guard and splitter assembly and adjust the
alignment with the blade as outlined earlier in the operator's
manual.
All manuals and user guides at all-guides.com
0° BEVEL STOP (FIG. 17)
1. Raise the blade to maximum height by rotating the hand-
wheel counterclockwise.
2. Loosen bevel angle lock knob.
3. Tilt the blade to 0° bevel.
4. Using a square (1), verify blade is 90° to the table top.
5. If blade is not 90° to the table, back off the adjustment
Fig. 16
6. Loosen bevel lock knob and square blade 90° to the table.
7. Once blade is at 90° to the table top, lock bevel angle
8. Carefully tighten adjusting screw (2) until it touches
9. Recheck to ensure blade is still aligned at 90°.
BEVEL POINTER ADJUSTMENT (FIG. 18)
When you have achieved a 90° angle of the blade to the table
top as described in section above, the angle pointer (1) may
require adjustment. If so, follow proceeding steps:
1. Loosen pointer screw (2) and move the pointer so it is
aligned with 0° on the bevel scale.
2. Retighten the pointer screw.
13
screw (2).
locking knob.
the bevel stop. DO NOT OVERTIGHTEN.
Fig. 17
Fig. 18