Declaration Of Conformity - Felisatti SG6/750 Instrucciones De Servicio

Ocultar thumbs Ver también para SG6/750:

Instrucciones de servicio (37 páginas)

Contenido

página de 42

/ 42
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

any reason, switch off the power tool and hold the power

tool motionless until the wheel comes to a complete stop.

Never attempt to remove the cut-off wheel from the cut

while the wheel is in motion otherwise kickback may occur.

Investigate and take corrective action to eliminate the

cause of wheel binding.

Do not restart the cutting operation in the workpiece.

Let the wheel reach full speed and carefully re-enter the

cut. The wheel may bind, walk up or kickback if the power

tool is restarted in the workpiece.

Support panels or any oversized workpiece to

minimize the risk of wheel pinching and kickback. Large

workpieces tend to sag under their own weight. Supports

must be placed under the workpiece near the line of cut

and near the edge of the workpiece on both sides of the

wheel.

Use extra caution when making a "pocket cut" into

existing walls or other blind areas. The protruding wheel

may cut gas or water pipes, electrical wiring or objects that

can cause kickback.

Safety warnings specific for polishing operations

Do not allow any loose portion of the polishing

bonnet or its attachment strings to spin freely. Tuck away

or trim any loose attachment strings. Loose and spinning

attachment strings can entangle your fingers or snag on the

workpiece.

Safety warnings specific for wire brushing

operations

Be aware that wire bristles are thrown by the brush

even during ordinary operation. Do not overstress the wires

by applying excessive load to the brush. The wire bristles

can easily penetrate light clothing and/or skin.

Allow brushes to run at operating speed for at least

one minute before using them. During this time no one is

to stand in front or in line with the brush. Loose bristles or

wires will be discharged during the run-in time.

Direct the discharge of the spinning wire brush away

from you. Small particles and tiny wire fragments may be

discharged at high velocity during the use of these brushes

and may become imbedded in your skin.

Additional safety warnings

Use suitable detectors to determine if utility lines are

hidden in the work area or call the local utility company for

assistance. Contact with electric lines can lead to fire and

electric shock. Damaging a gas line can lead to explosion.

Penetrating a water line causes property damage or may

cause an electric shock.

Release the On/Off switch and set it to the off position

when the power supply is interrupted, e. g., in case of

a power failure or when the mains plug is pulled. This

prevents uncontrolled restarting.

Secure the workpiece. A workpiece clamped with

clamping devices or in a vice is held more secure than by

hand.