Sebson WAL E LED Manual Del Usuario página 6


In commercial institutions, the accident prevention regulations of the professional trade association for
electrical equipment and facilities must be adhered to.
Instruction for installation (Fig 2):
Danger:
Before installing please make sure that the circuit is interrupted! For installation, the work on the mains
voltage is required. Please remove the associated mains fuse or deactivate the switch fuse! Check by using a
voltage tester if the line is de-energized. Make sure that the current circuit will not closed during the installation!
Danger:
The installation of this product may be done only by a qualified person according the valid regulations for
electrical installation!
Attention:
Before drilling the mounting holes, make sure that there are no gas, electricity or water pipes at the
drilling location that could be damaged by this!

Please observe the safety instructions and technical data before installing this product!

Note on installation:
L: Live wire (black or brown)
N: Neutral conductor (blue or grey)
Technical Data:
Operating voltage:
Nominal wattage:
Nominal luminous flux:
Rated color temperature:
Electrical protection:
Protection class:
Ambient temperature:
Humidity:
This product contains a light source of energy efficiency class G.
Disposal note:
This product may not be disposed of with household waste. At the end of its useful life, the product must be
returned to a point of acceptance for the recycling of electric and electronic device. Please ask your local
municipality for the point of acceptance! As the devices contain valuable recyclable materials, they should be sent
for recycling, in order not to harm the environment or human health from uncontrolled waste disposal.
Cleaning:
Danger:
Before start cleaning the product interrupt the current circuit by switching off the circuit breaker or unscrew
the fuse! Use a slightly moistened cloth for cleaning. In order not to damage the product, it is essential to avoid water
penetrating into the housing! Never clean the device under running water! Do not use solvent-containing cleaner for
cleaning.
Address :
SEBSON
Sebastian Sonntag
Gernotstr.17
44319 Dortmund
220-240V AC 50/60Hz
15W
1.100lm
5.800K
IP54
II
-20° - +40°C
<93%
6