Klarstein 10034153 Manual De Instrucciones página 62

EN
62
Check exhaust gas temperature
Note: The combustion parameters are factory configured, normally no
adjustment is required. When setting the calorific value difference of the
pellets, please avoid overfilling the pellets as this will cause too much fire,
waste the pellets and shorten the life of the heater.
This allows you to check if the fire is too strong:
During normal operation, press the button
temperature, which should be lower than the factory setting of ≤ 200 °C. If the
flue gas temperature is too high, the fire is too strong. In this case, reduce the
pellet quantity.
Setting the convection motor speed
Press the button
There are 5 speed levels, ranging from the first to the fifth. The first stage is the
weakest stage and the fifth stage is the strongest stage. The adjustable speed
of the convection motor depends on the set fire power level:
to access the speed settings of the convection motor.
to check the flue gas