LUND SUMMIT RIDGE 2.0 Instrucciones De Instalación página 3

7. Level and adjust the running board and fully tighten all hardware.
8. Repeat Steps 1—7 to install the remaining running board on the Driver/left side of the vehicle.
9. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be used also to clean the
Running Board.
Front
(Fig 1) Passenger/right side Rocker Panel mounting locations illustrated (arrows) NOTE:
Hold Bracket up to body panel to help determine the correct mounting locations.
Front
(Fig 2) Remove plastic plugs to
uncover threaded inserts
Passenger/right side Installation Pictured
Remove plugs
SUMMIT RIDGE 2.0 RUNNING BOARDS
2019 1500 SILVERADO/SIERRA CREW CAB
Front
(Fig 3) Passenger front mounting location
Page 2 of 4 10/17/18 (RA)