LUND Terrain HX Nerf step Instrucciones De Instalación

Installation I nstructions
I -­‐Sheet N umber T HX03
Hardware Kit Contains
(14) 3/8" x 1" Hex Bolts
(14) 3/8" Washers
(14) 3/8" Threaded Clips
Step 1: Locate the driver's side Nerf Step by matching the shorter tail bend to the front of the vehicle.
NOTE: Some models have a straight cut end with a cap; on these models the capped end goes to the rear of the vehicle.
Step 2: Beginning with the driver's side; locate the six sets factory mounting hex holes (3 on each side of the vehicle).
These are positioned on the vertical sides of the floor pan beneath the doors, with one set of holes each in the front,
middle, and rear of the vehicle cab.
Step 3: Using the 3/8" threaded clips, slide two clips in the upper rectangular hole, and align one clip in each hex hole so
the clip threads are visible. See Figure 1 or 2
Figure 1 : 0 9 -­‐ 1 4 R AM 1 500, 2 500,
3500, e xc. 2 014 1 500 Q uad
Step 4: Align the Nerf Step brackets with the three mounting locations on the underside of the vehicle. Start all six 3/8" x
1" hex bolts with washers and hand tighten.
Step 5: Using a sharpie, outline the upper "U "shaped mount in the center bracket.
4325 H amilton M ill R d. S te. 4 00 | B uford, G A 3 0518 | 8 00.241.7219 | l undinternational.com
C ab.
PART N UMBER: 3 4641334, 3 4641371,
3 4641358
PRODUCT: T errain H X N erf s tep
APPLICATION: 0 9-­‐15 R AM 1 500
1 0-­‐15 R AM 2 500/3500
Recommended Tools
Socket Set
Figure 2 : 2 014 R AM 1 500 Q uad C ab,
rear m ounting l ocations.