Dimplex CEL50 Manual Del Propietário página 13

Fireplace Installation
Figure 9
Key-hole
Permanent
mounting hole
forward to allow the partially
reflective glass to fall out of
the inside framing.
CAUTION: Partially reflective
glass is not tempered. Do
not bump or drop the partially
reflective glass to avoid breakage
and personal injury.
• Remove partially reflective
glass from fireplace.
4. Position the fireplace on a wall
at the position where it will be
mounted (Figure 9). Use a
bubble level (one is supplied)
to ensure that fireplace is level
on the wall.
5. Ensuring that at least two key-
holes line up with a wall stud
(key-holes are spaced at 4"
(10.2 cm) centers), mark the
Wall stud
6. Remove fireplace from wall
7. Where marked screw locations
8. Screw all four supplied #8, 1½"
9. Align chosen key-holes with
10. Tighten all four mounting
11. Screw the two supplied #8
location of four screw locations
on the wall (through key-
holes).
and store in a safe place away
from traffic.
do not line up with a wall stud,
insert (screw in) one of the two
supplied wall anchors (predrill
if required). Repeat if only two
screws line up with a wall stud.
(3.8 cm) square head mounting
screws and washers into
the wall and/or wall anchors
leaving ¼" (6.5 mm) of thread.
screws and hang fireplace
on the wall. Screw heads
and washers will fit through
keyholes and fireplace will
slide down into place (screws
will slide into narrow part of
keyholes).
screws down on fireplace
chassis.
square head screws through
two of the permanent mounting
holes which align with a wall
stud.
13