Tabla de contenido
Publicidad
3. When fully charged, the device operates continuously for around 45 minutes.
WARNING: The device is designed to be used only dry, do not use in the shower or clean the blade
in water. Do not use with foam or shaving gel.
HEAD REPLACEMENT
To change attachments, hold the trimmer body with the power switch side (1) facing towards you.
Turn the attachment counter-clockwise and take off from the base (5). Then take a different
attachment place it on the base (5) and move clockwise. Be sure that the attachment is properly
mounted on the base (5).
USING THE TRIMMER
Slide the power switch (1) up to turn the device on. Apply the blade to the skin so that the flat
surface of the blades rests flat against the shaving area. For best results, the movement of the
blade should be carried out in the opposite direction of hair growth (not applies to bikini trimmer (C)
and nose/ear trimmer (E)).
Do not move the shaver too fast. Slow and steady movements give the best results. Also use when
skin and hair are completely dry.
(A) Foil shaver - use it for large surfaces like arms and legs. Use the guide comb to cut hair more
evenly.
(B) Eyebrow trimmer - use this attachment for trimming unwanted eyebrow hair, fine facial hair or
any stray body hair. Use the guide comb to cut hair more evenly.
(C) Bikini trimmer – use it for bikini area. Trim or shave in the same direction where your hair
grows. Pull your skin lightly to let bikini trimmer glide smoothly. Use the guide comb to cut and style
the longer hair more evenly.
(D) Round face shaver – use it for trimming unwanted facial hair or any stray body hair.
(E) Nose / Ear trimmer - prior to using the trimmer ensure that the nasal passage and outer ear are
clean. Place the end of the trimmer no deeper than 5mm in your nostril or ear. Gently moving the
trimmer, remove only the hair protruding outside of the ear or nose. If you experience any pain or
discomfort when using this product STOP using it immediately.
CLEANING AND MAINTENANCE
1. Clean your personal trimmer after each use.
2. Be sure that device is switched off before cleaning.
3. Never expose trimmer base (5) to water.
4. All trimmer attachments have rust resistant stainless steel cutting blades. They can be rinsed
under running water. Do not wash attachments (A,B,C,D,E) when attached to trimmer.
NOTE: Use attached brush to clean product.
IMPORTANT: Use trimmer again only if it's completely dry.
TECHNICAL DATA
Charger voltage: 5V 1A
5
Publicidad
Tabla de contenido
