Jean Louis David JLD-2102 Manual De Instrucciones página 12

NOTE: Always ensure your hair is clean, well combed, tangle-free and dry before using the appliance. Do not use hair sprays,
water vaporizers or any other vaporizers when operating the appliance.
NOTE: If you are not used to cutting hair, begin with the cut comb for a longer hair length and then reduce it, to avoid cutting
more hair than desired.
NOTE: When using the appliance for the first time, first try it on an area with light hair growth.
NOTE: Use a slow and controlled movement. Do not force the appliance through the hair faster than it can cut it. To control the
result during cutting, regularly comb the hair in the desired style.
NOTE: During the operation, shake or blow off the hair from the cutting head and cut comb, if too much hair is caught in them.
Charging the battery
— The battery capacity (in percentage) is indicated on the LED display during operation.
— If it shows a low battery capacity, press the on/off button to switch off the appliance.
— Connect the charging adapter with the charging jack on the charging base and plug it into a suitable power socket. Place the
appliance onto the charging base and ensure it sits properly in place.
— The battery capacity and symbol are indicated on the LED display during charging.
— After the battery is fully charged, the battery capacity shows 100% on the LED display.
— Remove the appliance from the charging base and disconnect the charging adapter from the power supply.
Locking the on/off button
— To avoid accidental switching-on, keep pressing the on/off button for approx. 2 - 3 seconds to lock it. The symbol flashes on
the LED display and goes out afterward.
— Keep pressing the on/off button for approx. 2 - 3 seconds to unlock it.
— The on/off button cannot be locked while charging the battery.
Cutting the hair
— Always switch off the appliance when attaching, detaching or changing the cut comb.
— Select the suitable cut comb (3 mm / 6 mm / 9 mm / 12 mm) for the desired hair length. Ensure the cut comb is properly fixed
on the cutting head.
INSTRUCTIONS FOR USE
12