Saitek CYBORG 5.1 Manual Del Usuario página 2

DM31QSG_MP.qxd 14/08/2008 10:05
FL
CEN
RL
2.1/5.1 mode
switch
Power on/off
2
All manuals and user guides at all-guides.com
Page 2
FR
RR
Setting up the Cyborg 5.1 Speakers
1. First, position the speakers around your PC as shown in the
diagram left. As you look at your PC, the single speaker unit with
the red phono plug should be on the right, the single speaker unit
with white phono plug on the left and the double speaker unit with
the black phono plug in the centre.
Position the rear speaker units behind you. Again, the speaker unit
with red plug to your right and the unit with white plug to your left.
2. Insert the speaker plugs in the corresponding sockets on the
subwoofer, connect the remote control and plug the subwoofer into
the mains power supply and switch it on.
3. On the back of your PC:
Insert one of the 3.5mm audio
jackplugs into the front channels
socket and the white phono plug at
the other end into the FL socket and
the red phono plug into the FR input
socket on the subwoofer.
Insert another 3.5 mm audio jackplug
into the rear channels socket and the
white phono plug at the other end into
the RL socket and red phono plug into
the RR input socket on the subwoofer.
Insert the third 3.5 mm audio jackplug
into the centre channel and subwoofer
socket and the white phono plug at
the other end into the SUB input and red phono plug into the CEN
input on the subwoofer.
4. For maximum bass effect, place the subwoofer on the floor under
your desk/table.
5. Power up the speaker system power by pressing the on/off switch
on the remote control unit. With the Cyborg speakers' volume
control at 0, open a 5.1 audio source, eg DVD, on your PC and
adjust the volume level to three quarters. Now turn up the Cyborg
speakers' volume to the desired listening level.
3
PC 5.1 outputs
Front channels Rear channels Centre channel
and subwoofer
FL FR RL RR SUB CEN