Chicco neuvo Manual De Instrucciones página 13

Ocultar thumbs Ver también para neuvo:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 23
locked (if so, a green icon showing a closed padlock is visible).
USING THE SAFETY HARNESS
This stroller has a five-point safety harness featuring two shoul-
der straps, two adjuster slots, a waist strap and a crotch strap with
buckle.
WARNING: when carrying children aged 0 to 6 months, the shoul-
der straps must be passed through the 2 adjuster slots before
being fastened.
5. After laying the child in the stroller, fasten the straps (Fig. 5)
by passing first the two forks (A) inside the shoulder strap slot
(B) and then fitting them inside the crotch strap buckle (C);
Adjust the height of the shoulder straps so that they adhere
to your child's shoulders. Make sure that the harness straps
are fitted correctly. To unfasten the waist strap, press and pull
ca-
the side prongs.
on
WARNING: Children should be harnessed in at all times. To ensure
oid
your child's safety, it is necessary to always use the safety harness.
ake
HOW TO ADJUST THE BACKREST
are
The backrest can be adjusted to several positions.
6. The inclination can be adjusted by pressing the button on
the stroller's backrest; By releasing the button, the backrest
ng
will lock in the nearest position. Simply push the backrest up
act
to raise it again (Fig. 6-6A).
uct
WARNING: The child's weight can make these operations more
bly:
difficult.
ADJUSTING THE LEG REST
7. The leg rest can be adjusted to ensure your child's utmost
comfort (Fig. 7). To adjust the leg rest in the desired position,
turn both levers together as shown in Fig. 7A. To return the
leg rest to its starting position, press the two lateral buttons
at the same time (Fig. 7B).
REAR BRAKES
The rear wheels have linked brakes, which can be applied simul-
taneously on both rear wheels by using one pedal alone.
ble
8. To apply the brakes, press one of the two levers on the centre
of the rear wheel group down, as shown in Fig. 8.
9. To release the brakes, press one of the two levers on the cen-
tre of the rear wheel group up, as shown in Fig. 9.
SWIVEL WHEELS
as
The front wheels on this stroller swivel.
he
10. To make the wheels swivel, lift the lever found between the
hey
two wheels (fig. 10). Use the swivel wheels on smooth surfa-
ces. To use the wheels in fixed mode, press the lever down
(Fig. 10A).
ed
The swivel wheels make the stroller easier to handle; it is howe-
he
ver recommended to use the wheels in fixed mode on uneven
ground to guarantee better stability (on gravel, unpaved roads
e it
etc.)
ess
WARNING: Both wheels must always be locked or unlocked at the
lar
same time.
STORAGE BASKET
by
The stroller is equipped with a storage basket.
11. To fasten the storage basket to the stroller's frame, fit the
slots in the relevant front hooks under the seat (Fig. 11). To
way
complete assembly, hook the basket's straps on the rear legs
of the stroller (Fig. 11A).
he
BUMPER BAR – TRAY
ice
12. The stroller features a bumper bar that also serves as a tray
Fig.
(Fig. 12)
ith
13. To remove the bumper bar – tray, use the levers in the lower
part of the component (Fig. 13)
in
14. To fit the bumper bar – tray back on, make its extremities sli-
ally
de into the relevant guides on the stroller's armrests (Fig. 14).
WARNING: The bumper bar - tray must not be used to lift the
stroller with the child inside.
WARNING: To prevent burns, never put hot beverages on the bu-
mper bar - tray.
CANOPY
15. To secure the hood, fasten the plastic clips to the locking pins
(Fig. 15-15A). Make sure that they are fastened correctly on
both sides. The rear panel can be fastened to the seat's fabric
hood using the relevant zipper (Fig. 15 B).
16. To open/close the hood, just pull/push the front part of the
hood (Fig. 16).
ACCESSORIES
BEVERAGE HOLDER
17. Fasten the beverage holder on the right rear tubular bar. To
fasten it, refer to Fig. 17-17A. WARNING: Do not load the be-
verage holder with weights over 0.5 kg.
RAIN COVER
18. To fit the rain cover, fasten the straps around the stroller's fra-
me, in the positions shown in Fig. 18. When you have finished
using the rain cover, allow it to dry properly if it is wet.
WARNING: the rain cover cannot be used on a stroller which has
no hood or sun-hood as it could suffocate the child.
WARNING: when the full-cover rain cover is fitted on the stroller,
never leave it exposed to direct sunlight with the child inside, as
the temperature will rise considerably.
MOUNTING THE CAR SEAT
The Neuvo stroller mounts the CHICCO KEYFIT car seat only.
WARNING: The KEYFIT car seat is not supplied with the stroller; it
must be purchased separately.
WARNING: When fastened to the stroller, the KEYFIT car seat can
be used for children from birth up to 13 kg in weight or until they
are able to sit by themselves.
Before mounting the KEYFIT car seat, lower the backrest com-
pletely and make sure the bumper bar/tray is fastened correctly.
WARNING: Never install the KEYFIT car seat without the bumper
bar/tray mounted on the stroller frame.
19. When the stroller is in open position, close the sun hood.
While keeping the car seat's handle in vertical position, you
can mount the car seat on the stroller (Fig. 19). Make sure
that it is fastened correctly. You will hear a "click" on each side
when it is hooked into position.
WARNING: the KEYFIT car seat can be installed on the stroller in
"parent facing" position ONLY. NEVER mount the car seat "facing
the road".
WARNING: Before use, check correct fastening of the car seat, by
pulling it up strongly.
To release the car seat from the stroller frame, just press the rear
orange button as shown in Fig. 19A and lift the car seat by the
handle.
WARNING: The fastening and release operations can be carried
out also with your child inside the car seat; however, these ope-
rations may be more difficult to execute with the child's weight.
CLOSING THE STROLLER
Before closing the stroller, make sure that the storage basket is
empty and that the hood is closed.
20. To close the stroller, pull the rear locking mechanism up (Fig.
20).
21. Release the additional safety device by pressing your foot on
the pedal on the right side of the frame (Fig. 21).
22. To close the stroller completely, push the handles forward
(Fig. 22).
23. The stroller features an automatic locking mechanism. Close
the stroller until the hook on the side locks. This is to avoid

Publicidad

Tabla de contenido
loading

Tabla de contenido