Festool DOMINO XL DF 700 EQ Manual De Instrucciones página 14

Lift the unlocking device [7-2] until it audibly
disengages using the open-ended spanner [7-
3] supplied (SW 12).
Separate the motor unit [7-5] from the guide
frame [7-4].
Press and hold the spindle lock [8-1].
Loosen the cutter [8-3] using the open-ended
spanner [8-2] and remove.
Release the spindle lock [8-1].
8-1
8
Inserting the tool
WARNING
Risk of injury
Before inserting a new cutter ensure that the
machine, the guide frame and the guides [7-1]
and [7-6] are clean.
Remove any contamination that may be present.
Only use sharp, undamaged and clean tools.
Press and hold the spindle lock [8-1].
Use the open-ended spanner [8-2] to screw on
the cutter [8-3].
Release the spindle lock [8-1].
Slide the guide frame [7-4] onto the motor unit
[7-5] until it audibly engages.
Setting stop pins
The stop pins on the front of the fence are used to
register the tool against the edge of the workpiece.
14
All manuals and user guides at all-guides.com
8-2
8-3
This provides rapid and precise placement of the
tool on the workpiece.
Six stop pins [9-2] are available on the stop side of
the DOMINO joining machine.
Stop pins that are not required can be individually
engaged by exerting overpressure and released us-
ing the button [9-1].
9-2
50 mm
37 mm
20 mm
1 2 3
A
B
C
These serve as spacers to the cutter centre and can
be inserted at different locations - see image [9]:
A Three possible spacings to a supply side (1 -
2 - 3)
B Two dowel holes beside each other from a
supply side (1 - 3)
C Two dowel holes by changing the workpiece,
e.g. for cross-section cut.
Widening the contact surface
The contact surface widening device [10-1] can be
used to enlarge the contact surface when routing
9-1
3 2 1