Install Custom Overlay Frame; Important - JENN-AIR JUW248RBCX Manual De Uso

Clean Before Using
After you remove all of the packaging materials, clean the inside of
your wine cellar before using it. See the cleaning instructions in
"Wine Cellar Care."

Install Custom Overlay Frame

IMPORTANT:

Create custom overlay frame according to the specifications
in the "Custom Overlay Frame" section.
Jenn-Air is not responsible for the removal or addition of
molding or decorative panels that would not allow access to
the appliance for service.
Remove the Door
IMPORTANT: Do not remove the grease from the washer, top
spacer or top hinge pin. Be sure to set aside the top hinge, top
spacer and washer for later use.
1. Using a Phillips screwdriver, remove the three screws from the
top hinge. Remove the top hinge.
A. Screws (3)
B. Top hinge
C. Washer
D. Top spacer
E. Door
2. Remove the three screws from the top spacer. Remove the
top spacer and washer.
3. Open the door. Lift the front of the door up, pulling straight out
to remove as shown.
6
Attach the Overlay Frame
NOTE: If the overlay hooks are not installed, see "Custom Overlay
Frame" for overlay hook locations.
1. Position the overlay frame ¹⁄₂" (1.27 cm) higher than the door.
Be sure to position the overlay hooks to the pilot holes.
A
2. Insert the overlay hooks into the top of the holes in the door.
B
Push against the overlay frame to force the overlay hooks
deeper into the door. Pull the overlay frame straight down to
secure the overlay hooks to the door.
C
3. Using a Phillips screwdriver, attach the overlay plates to the
bottom of the overlay frame and door as shown.
D
E
Install the Door
IMPORTANT: To ensure proper operation, be sure to grease the
top hinge, top spacer and washer with petroleum jelly.
1. Using a Phillips screwdriver and three screws, attach the top
spacer to the door.
2. Using petroleum jelly, grease the bottom spacer hole and the
bottom hinge pin. Align the washer with the bottom spacer
hole.
A B C D
A. Overlay frame
B. Door
C. Overlay plates (2)
D. Round-head screws (8)