Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Prior to shipment, this gun was treated
with an anticorrosive agent. Before
using this gun make sure that it is
carefully flushed with thinner.
(E) Non-Drip Cup
(F) Material
Filter
(H) Horns
(G) Air Cap
(A) Air
Valve Nut
1.
The position of the air cap (H)
horns will determine the spray
pattern. Loosen (G) air cap and
rotate horns to achieve desired
pattern. Tighten air cap.
Horizontal position
Vertical position
2.
Attach material cup to the gun.
NOTE: The (F) material filter
supplied is optional to protect
against contaminants and small
particles. See parts list for
material filter orientation.
All manuals and user guides at all-guides.com
3.
4.
(D) Fluid
Control
5.
Knob
Adjust spray gun:
a.
(B) Spray
Pattern
Adjustment
(C) Air
Volume
b.
Control Knob
c.
NOTE: Care should be exercised when
handling spray gun to avoid damage to
the orifice of the air cap and tip of fluid
nozzle. Damage to these parts results
in irregular spray patterns.
5- ENG
Attach air supply line to 1/4 NPS
air inlet.
NEVER point
spray gun at self
or any other person. Accidental
discharge of material may result
in serious injury.
Adjust air pressure at air compres-
sor.
DO NOT exceed
100 psi.
Depress spray gun trigger fully to
spray material. NOTE: Depressing
trigger partially will cause only air
to be released.
Amount of material released (den-
sity of "fan spray") is controlled by
(D) fluid control knob. Turn knob
counterclockwise to increase, or
clockwise to decrease, the fluid
flow.
Width of "fan spray" is governed
by (B) pattern adjustment knob.
Turn knob counterclockwise to in-
crease, or clockwise to decrease,
air flow.
Air quantity is controlled by (C)
air-volume control knob. Turn
knob counterclockwise to in-
crease, or clockwise to decrease,
the air flow.
D28996
Publicidad
Tabla de contenido
