Overmax Camspot NVR 8.0 Manual Del Usuario página 19

3. How to install and connect
a) How to connect elements (see fig. 3):
1.
Use a screwdriver to remove the top cover. Install the
recorder hard drive.
2.
Fix the hard drive cable and feeder cable and then
screw the drive on to the casing
3.
Once you have mounted the drive, connect the mouse
and display unit. Switch the device on and connect
power supply to IPC. Make sure NVR works properly.
NVR is connected to the display unit and all IPCs are located
by NVR. The recorder may be installed in a default location.
b) How to place camera in default position
1.
Fix the wireless camera in a default position, at
relevant distance and connect the power supply.
2.
After a couple of minutes the camera image will show
up automatically on the display unit.
3.
If you cannot see any image, reduce distance between
the camera and recorder.
NVR aerial emits a signal. It is best if the IPC aerial is turned
towards the recorder to assure best signal.
4. How to switch on and log in (see fig. 4):
1.
Connect the feeder. The light on the front panel of the
recorder will go red.
2.
The device will start.
3.
Once the system has been activated, the display unit
will automatically display interface preview and login
page. The user needs to log in to go to next step.
Steps:
1.
Press the user name box with a left key of the mouse
and enter it. The default login is „admin".
2.
Press the password box with a left key of the mouse
and enter it. The default password is „admin".
EN