Craftsman 139.30498 Guia De Inicio Rapido página 2

PROGRAM THE REMOTE CONTROL (139.30499)
1
Using a safety pin or paper
clip, press the Program button
until the LED on the front of
the remote control turns on.
4
To exit programming mode, press
any remote control button except
the button that was just programmed.
BATTERY
The LED on your remote will stop flashing when the battery is low and needs to be replaced.
To replace battery, open the case as shown. Insert battery positive side up (+). Replace the battery
with only 3V2032 coin cell batteries. Dispose of old battery properly.
139.30498
Pry open the case first in the middle (1), then
at each side (2 and 3) with the visor clip.
2
1
3
REPLACEMENT PARTS
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10A20
Visor Clip
(Model 139.30498 ONLY) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29B137
2
Press and
release the
Learn button
on the garage
door opener.
The Learn LED will light.
Within 30 seconds...
5
To test, press the programmed button on the remote control...
Pry open the case with a screwdriver blade.
3
Press and release the remote
control button you want to use...
Check to see if the garage door opener
light bulb blinks. If not, wait for the
remote control LED to light solid then
slowly press and release the remote
control button again. Repeat until the
light bulb blinks.
DO NOT press the button after the
light bulb blinks.
139.30499
1-800-4-MY-HOME
The garage door opener
will activate.
To prevent possible SERIOUS INJURY or
DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify
doctor.
To reduce risk of fire, explosion or chemical
burn:
• Replace ONLY with 3V2032 coin batteries.
• DO NOT recharge, disassemble, heat
above 212° F (100° C) or incinerate.
NOTICE: To comply with FCC and or Industry Canada rules (IC),
adjustment or modifications of this receiver and/or transmitter
are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE
PARTS.
Tested to Comply with FCC Standards for Home or office use.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
To order replacement parts call...
® (1-800-469-4663)