Homewerks Worldwide BFP-069L-V5.0 Instrucciones De Instalación

Replacement Bluetooth
Installation Instructions
Speaker model BFP-069L-V5.0 for Bath Fan model 7130-03-BT
Speaker model BFP-218-V5.0 for Bath Fan models 7130-04, 7130-08, 7130-14,
7130-15, 7130-18-BT
Speaker model BFP-230-V5.0 for Bath Fan model 7130-13-BT
Tools needed: Philips Screwdriver (+)
1) If the bath fan is installed, remove the grille by squeezing the
mounting springs and pulling the grille down from the fan
housing. Disconnect the connectors to remove the grille from the
fan housing, as shown in Figure 1.
2) Note the placement of the speaker and how the wires are
installed. You want your installation to look exactly the same when
complete.
3) Unscrew the 4 screws holding the speaker in place
using a screwdriver. Retain the screws. Remove the speaker and
attached wiring.
4) Insert the new speaker into the grille. Align the screw holes,
remembering the previous placement as noted in step 2.
Reinstall the screws removed in step 3.
5) Join the connectors for the Bluetooth
the fan housing to the grille, as shown in Figure 2. Attach the grille
by pinching the mounting springs and inserting them into the
narrow rectangular slots in the fan housing.
6) Turn on the power source. Test the unit.
If not operating properly, please contact customer service at
1-877-319-3757 or send an email message to Info@HWCares.com
BFP-069L-V5.0
Homewerks.com
Speaker Kit
®
speaker and LED light from
®
BFP-218-V5.0
© 2021 Homewerks Worldwide, LLC
Figure 1
Housing
slots
Mounting
springs
Disconnect the wiring
Bath fan models will vary
Figure 2
Housing
slots
Mounting
springs
Reconnect the wiring
Bath fan models will vary
.
BFP-230-V5.0
Connectors
Grille
Connectors
Grille
REV.: 8/4/21