Cleaning And Maintenence - Max Pro MPAG 650/100 Manual Del Usuario

Risk of injury!
When using cutting discs, splinters may come away from the cutting disc during cutting and spin off.
- When cutting, we recommend use the special protective cover.
High risk of injury!
Fragments of cut-off discs may be projected at a very high velocity.
- Do not apply any lateral pressure to the disc as the cut-off disc may tilt and burst.
1. Remove the protective cover
2.Attach the protective special cover
3. Mount a cut-off disc.
4.Turn on the device and allow it to run without applying a load.
Hold the motor block at an angle of 30
5.
6.Slowly and evenly run the disc along the designated cut-off line.
Before any work on the machine itself, pull the mains plug.
For safe and proper working, always keep the machine and ventilation slots clean.
In extreme working conditions, conductive dust can accumulate in the interior of the machine when working
with metal. The protective insulation of the machine can be degraded. The use of a stationary extraction
system is recommended in such cases as well as frequently blowing out the ventilation slots and installing a
residual current device (RCD).
Please store and handle the accessory (-ies) carefully.
If the machine should fail despite the care taken in manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for Maxpro power tools.
Do not dispose of electric tools, accessories and packaging together with household waste material
- in observance of European Directive 2002/96/EC on waste of electric and electronic equipment and its
implementation in accordance with national law, electric tools that have reached the end of their life must
be collected separately and returned to an environmentally compatible recycling facility
Fault Symptom
1 Out of service
Sluggish start-up,
2 falling short of
running speed
Excessive
3 sparkling during
running
11
All manuals and user guides at all-guides.com
Angle Grinder MPAG650/100 User Manual
0 0
to 45 to the work piece.

CLEANING AND MAINTENENCE

ENVIRONMENT
TROUBLE SHOOTING
Possible Cause
Disconnection between plug and power socket
shortcircuit in power supply
At switch-off
Loose switching contact
Damage in soft starting block
Burnout of stator or rotor coil
Stator wiring disconnection
Disconnection between carbon brush and
commutator
Unsmooth running in mechanical part
Low supply voltage
Burnout of switch contact
Underpressure in carbon brush spring
Excessive wearout of carbon brush
Ring fire caused by shortcircuit in rotor winding
shortcircuit
Ring fire caused by shortcircuit in commutator
segment
Put plug in power socket
Repair and reconnection
Switch on
Replace switchboard by repairer
Replace soft starting block by repairer
Replace stator or rotor by repairer
Reconnection by repairer
Replace carbon brush
Check mechanical part by repairer
Regulate supply voltage
Replace switchboard by repairer
Replace carbon brush by reparier
Replace carbon brush by reparier
Check or replace rotor by repairer
Check or replace rotor by repairer
GB
Troubleshooting