Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
PART #317754
Step 1 - Assemble crossbrace subassembly.
• Assemble middle, corner, and end castings to rear
knockdown tubes and front-to-back crossbracing.
• Tighten set screws.
front-to-back
crossbracing
end
casting
www.southwestsolutions.com
Eagle Foodservice Equipment, Eagle MHC, SpecFAB, and Retail Display are divisions of Eagle Group. ©2007 by the Eagle Group
Worktable with Tubular Base
ASSEMBLY INSTRUCTIONS
INSPECT CONTENTS IMMEDIATELY AND FILE CLAIM WITH
DELIVERING CARRIER FOR ANY DAMAGE
SAVE YOUR BOX AND ALL PACKING MATERIALS.
YOU ARE RESPONSIBLE FOR DAMAGE TO YOUR UNIT
IF RETURNED IMPROPERLY PACKED.
Please note: Assembly shown for unit with six legs.
rear knockdown tube
middle casting
corner
casting
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S.A. • www.eaglegrp.com
• Phone: 302/653-3000 • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: 302/653-2065
CAUTION
Step 2 - Attach crossbrace subassembly to legs.
Note: To meet NSF
requirements, attach
crossbrace subassembly
6˝ from floor.
• On legs, measure and
mark desired height of
crossbrace subassembly.
• Insert legs.
• Snug the set screws.
.
crossbrace
leg
subassembly
(continued on back page)
EG9805 Revised 01/07
Publicidad
Resumen de contenidos para Southwest 317754
- Página 1 Worktable with Tubular Base PART #317754 ASSEMBLY INSTRUCTIONS CAUTION INSPECT CONTENTS IMMEDIATELY AND FILE CLAIM WITH DELIVERING CARRIER FOR ANY DAMAGE SAVE YOUR BOX AND ALL PACKING MATERIALS. YOU ARE RESPONSIBLE FOR DAMAGE TO YOUR UNIT IF RETURNED IMPROPERLY PACKED.
- Página 2 Worktable with Tubular Base ASSEMBLY INSTRUCTIONS Step 3 - Attach tabletop. • Turn tabletop upside-down (take care not to scratch the finish). • Turn crossbrace subassembly upside-down and insert top of each leg into each tabletop gusset. • Tighten all screws. tabletop gusset Level table with adjustable feet.
- Página 3 Mesa de trabajo con base tubular PIEZA Nº 317754 INSTRUCCIONES PARA EL ENSAMBLAJE PRECAUCIÓN INSPECCIONE EL CONTENIDO INMEDIATAMENTE Y PRESENTE UN RECLAMO AL AL TRANSPORTISTA DE LA ENTREGA EN CASO DE HABER DAÑOS. CONSERVE LA CAJA Y TODOS LOS MATERIALES DE EMBALAJE.
- Página 4 Mesa de trabajo con base tubular INSTRUCCIONES PARA EL ENSAMBLAJE Paso 3: fije la parte superior de la mesa. • Gire la mesa boca abajo (tenga cuidado de no rayar la terminación). • Gire hacia abajo el subensamblaje de la conexión en cruz e inserte la parte superior de cada pata en la unión de la parte...