1. Introduction ....................................................................... 3
4. Installation & Operating Instructions ................................. 8
5. Resin Change ................................................................... 10
6. Technical Data ................................................................. 11
Spare Parts .......................................................................... 13
Contents under pressure. Can cause severe
injury or death from tank rupture.
When starting system:
• Do not exceed pressure of 116 psi (8 Bar).
• Check system for cracks.
• Be sure cover is in locked position.
• Keep Water OUT connection open and hold yellow
lever down to remove trapped air from system.
• For use only with drinking (tap) water.
Before servicing system:
• Shut off tap water supply and open Water OUT
connection.
• Disconnect water supply and allow tank to drain.
• Before opening tank, Press yellow FastLock
opening lever to remove pressure the tank, rotate
handles counter-clockwise 1/8 turn, and remove top
cap using handles.
STORAGE: Do not store resin in open or unlabeled containers. Store in a cool, dry place
(15°F to 100°F).
DISPOSAL: Dispose of in accordance with applicable federal, state/provincial, and local regulations.
All HydroPower Ultra units require the use of mixed bed ion exchange resin (commonly referred to as
de-ionizing resin).
2
Table of Contents
DANGER
!
• Spilled resin is a slipping hazard. Clean up
spilled resin immediately.
• Resin can cause skin irritation.
Avoid skin contact.
• Wash hands thoroughly after use.
• Can cause eye irritation. Avoid eye contact.
Wear safety goggles. In case of eye contact,
immediately flush eyes thoroughly with clean
water. Consult doctor if symptoms persist.
• Do not drink the water produced by this
system.
READ OPERATING INSTRUCTIONS
BEFORE USING PRODUCT!
™
www.ungerglobal.com