Excalibur RES10 Manual Del Usuario página 9

After you choose the ZONE, the next screen will show you the Remaining Time and Set Temperature. At any time during the drying
process, you can move the cursor to change the time or temperature.
If you choose CANCEL SESSION, next screen lets you confirm yes or no.
SETTING 2 time / 2 temperature
This setting is most often used to speed up the drying process, decreasing the total drying time, by setting a period of time at a higher
temperature and a period of time at a lower temperature.
Set zone A for 2 time and 2 temperature.
•
OR Set zone B for 2 time and 2 temperature.
•
OR Set zone A+B for 2 time and 2 temperature.
•
From the Home Screen, with the > next to
2 time / 2 temp
With the > next to
Set Time 1 / Temp 1 and then Set Time 2 / Temp 2 ...
To change the hour, using the control panel, touch the > to move the cursor under the 1. When the cursor is blinking under the 1,
press the to increase the hours. To decrease, press the on the control panel.
When time setting is complete, press until the cursor is no longer blinking under the Hour or Minute field.
To Set the Temperature, press the on the control panel. The selection will move to > Set Temp.
To change the temperature, using the control panel, touch the > to move the cursor under the temperature #. When the cursor is
blinking under the #, press the to increase the degrees. To decrease degrees, press the on the control panel.
When temperature setting is complete, press .
To START the drying process, press the on the control panel. The selection will move to > Start. Press .
Dry It
press to Select the DRY IT option. The next screen will appear:
press to Select the 2 time / 2 temp setting option. The next screen will appear:
To see" Set Temp 2" and" Start"
you will need to scroll down
using the button.