Rapid EN330 Manual Del Usuario página 11

3. Open the magazine fully and insert the brads with the points facing
the bottom of the tool. Points must rest against the bottom of the tool
and the brad strip laying fl at against the magazine. (Figure 4).
Use only recommended brads.
4. Close magazine and make sure it is securely locked.
REMOVE BRADS FROM THE MAGAZINE
1. Turn off the power switch and unplug the nailer.
2. Squeeze latch and slide magazine open.
3. Remove the brads from the magazine.
4. Close magazine.
NAILING
1. Plug nailer into a 220-240V~, 50Hz power outlet.
2. Turn on the power switch (Figure 2)
3. Make sure the tool is in good working condition.
4. Hold the nailer fi rmly with the brad output
piece to activate the safety yoke
5. Squeeze trigger
6. To fi re the nailer again, release safety yoke and trigger then repeat
step 4 and 5.
7. The power adjuster
drive brads into hard materials or use the LO setting to drive brads
into thin or soft materials.
8. Unplug nailer, turn off power switch after use.
NOTE: For better performance press the tool against the work
piece (Figure 5).
NOTE: In case of jammed brad, read the maintenance section. DO
NOT re-fi re the tool in order to clear the jam as this may damage the
tool.
NOTE: During operation, the tool may feel warm. This is normal but
if the tool starts to feel hot use shall be discontinued until it cools down.
NOTE: The nailer should be used only for the intended purposes. It
is designed for use on wood or similar materials in indoor environment.
GUIDELINES FOR USING EXTENSION CORDS
Recommended Minimum Wire Area (mm
Up to 10m: 1.5 mm
Up to-25m: 2.5mm
Over 25m: not suitable
STANDARD MAINTENANCE
1. Unplug nailer before any maintenance.
2. Inspect all screws and tighten if necessary.
3. Keep all vents free from dust and dirt.
4. Clean tool by a dry or damp cloth. NEVER use any solvent.
5. Keep the magazine channel clean.
6. DO NOT oil or grease any parts.
OPERATION
to fi re the nailer.
has two power settings. Use the HI setting to
2
2
MAINTENANCE
.
fl at against the work
(Figure 5).
2
) for Extension Cords
11