Makita XAG01 Manual De Instrucciones página 6

Esmeriladora angular inalámbrica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Battery cartridge replacing signal
When the remaining battery capacity is low,
the indicator lamp lights up during operation
earlier than that of high battery capacity.
Accidental re-start preventive function
Even if the battery cartridge is inserted on the
tool with the slide switch in the "I (ON)" position,
the tool does not start. In this situation, the lamp
flickers slowly. It indicates that the accidental re-
start preventive function is at work.
To start the tool, first slide the slide switch
toward the "O (OFF)" position and then slide
it toward the "I (ON)" position.
Shaft lock
1
014076
CAUTION:
Never actuate the shaft lock when the spindle is
moving. The tool may be damaged.
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Switch action
007217
CAUTION:
Before inserting the battery cartridge into the tool,
always check to see that the slide switch actuates
properly and returns to the "OFF" position when
the rear of the slide switch is depressed.
Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, slide the slide switch toward the "I
(ON)" position. For continuous operation, press the front
of the slide switch to lock it.
To stop the tool, press the rear of the slide switch, then
slide it toward the "O (OFF)" position.
1. Shaft lock
1. Slide switch
1
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing side grip (handle)
007225
CAUTION:
Always be sure that the side grip is installed
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
007218
WARNING:
When
using
wheel/Multi-disc, flex wheel, wire wheel brush, cut-
off wheel or diamond wheel, the wheel guard must
be fitted on the tool so that the closed side of the
guard always points toward the operator.
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees. Be
sure to tighten the screw securely.
To
remove
wheel
procedure in reverse.
6
1. Wheel guard
1
2. Bearing box
3. Screw
2
3
a
depressed
center
guard,
follow
the
grinding
installation

Publicidad

Tabla de contenido
loading

Tabla de contenido