Klark Teknik DN200 Guia De Inicio Rapido

Quick Start Guide
DN200
2-Channel Active DI Box with Extended Dynamic Range and Sum/Split Options
(EN) Controls
(1) STEREO INPUT – Connect a line-level audio source via stereo
1/8" TRS cable. Ensure that the L/R INPUTS and LINK THRU jacks
are disconnected when using the STEREO INPUT jack.
(2) PAD – Press to reduce the input signal by 20 dB for use with
hot signals.
(3) EARTH – Press to separate the input and output grounds,
potentially eliminating earth/ground loops between
equipment on different mains supplies.
(4) L/R INPUT – Connect either balanced or unbalanced XLR
or 1/4" cables. Ensure that the 1/8" STEREO INPUT jack is
disconnected when using these inputs.
(5) 48 V LED – Lights when the unit receives sufficient
phantom power. Note that the DN200 must be powered
to operate correctly.
V 1.0
(2) (3)
(1)
(5)
(8)
(6) SUM – When engaged, the left and right inputs are summed
(7) SPLIT – When engaged, the left input is fed to the left and
(8) L/R OUTPUT – Send the signals to a mixer or recording
(9) LINK THRU – Send the signals to an alternate source via
(4)
(6) (7)
(9)
Important: Although the DN200 will function as a mono
device when only one channel is connected, both channels
should be powered to use stereo, split, or sum modes.
and fed to the left and right outputs. Note that phantom
power must be delivered to both output connections for
dual-output operation.
right outputs. Note that phantom power must be delivered
to both output connections for dual-output operation.
interface via balanced XLR cables. Note that the connected
device must be able to provide +48 V phantom power to
these connectors.
balanced or unbalanced 1/4" cables. Ensure that the 1/8" STEREO
INPUT jack is disconnected when using these outputs.