Assembly - A-iPower APW2700C Manual Del Propietario E Instrucciones De Operación

SETUP

ASSEMBLY:

1. Take out the end cap in the frame,attach
the handle on to the frame by inserting
the clip.See Figure A.
2. Attach the gun holder to the handle,rotate
the holder to get a comfortable angle and
then tighten the knob by hand.
See Figure B
3. Insert the hose holder into the holes on
the back of panel.
See Figure C.
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
4. Connect the Pressure Hose to the Pump
hand, DO NOT use any tool to tighten.
See Figure D.
Figure A
5. Connect the Pressure Hose to the
handle of the Spray Gun and tighten the
See Figure E.
Figure B
6. Remove the protective cap on the Wand
inlet. Insert the Wand into the Spray Gun
Figure C
See Figure F.
10
Figure D
Figure E
Figure F
Wand
Spray Gun Tip