ASROCK ALiveN570SLI-eSATA2 Manual Del Usuario página 20

All manuals and user guides at all-guides.com
2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2, No. 25)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2, No. 9)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATA II Connectors
(SATAII_1 (PORT1.0):
see p.2, No. 13)
(SATAII_2 (PORT1.1):
see p.2, No. 18)
(SATAII_3 (PORT2.0):
see p.2, No. 14)
(SATAII_4 (PORT2.1):
see p.2, No. 17)
(SATAII_5 (PORT3.0):
see p.2, No. 15)
(SATAII_6 (PORT3.1):
see p.2, No. 16)
SATAII_6 (PORT3.1) connector can be used for internal storage de-
vice or be connected to eSATAII connector to support eSATAII device.
Please read "eSATAII Interface Introduction" on page 26 for details
about eSATAII and eSATAII installation procedures.
2 0 2 0 2 0
2 0 2 0
ASRock ALiveN570SLI-eSATA2
connect the black end
to the IDE devices
80-conductor ATA 66/100/133 cable
These six Serial ATAII
(SATAII) connectors support
SATA data cables for internal
storage devices. The current
SATAII interface allows up to
3.0 Gb/s data transfer rate.
Motherboard
the red-striped side to Pin1