Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly and Operation
8
7
6
5
3
1
Ventamatic, Ltd.
P.O. Box 728, Mineral Wells, TX 76068-0728
CAUTION
4
WARNING
2
WARNING
MOUNTING THE FAN SUPPORT HOUSING ON
PEDESTAL
•
Attach BRACKET POST (4) to BASE (1) with 4 screws
and spring washers (2) as shown, tighten securely.
•
Loosen the PLASTIC ROUND NUT (5) on the
BRACKET POST (4) and extend the INNER TUBE (6)
to the desired height.
•
Slide the COVER RING (3) down onto the STAND
POST (4) and lay it on top of the BASE (1).
THE PLASTIC ROUND NUT (5) must be fully tightened
before assembling the MOTOR (8) to the INNER TUBE
(6).
ENGINE AND SUPPORT STATION MOUNTING
INSTRUCTIONS
•
Locate the MOTOR (8) and insert it into the INNER
TUBE (6).
•
Align hole in INNER TUBE (6), tighten screw and
washer (7) SECURELY.
•
Attach two 3-WING PLASTIC KNOBS (9) to the
TO ADJUST AIR FLOW ANGLE:
Tilt the fan head to the desired angle by loosening THE
SPEED CONTROL:
Turn the SWITCH to OFF (0), HIGH (3), MEDIUM (2) and
LOW (1) speeds for the respective air speed.
CLEANING:
Unplug it from the power source before cleaning it.
•
After maintenance, all safety devices (including
previously installed.
•
Use a soft, damp cloth to clean. Then clean it with a
dry cloth.
•
Do not use cleaning solutions that are harmful to
paints or plastics.
•
Do not bend the blades.
•
The motor bearings are permanently sealed and do
This product is not intended for use by persons
(including children) with reduced physical, sensory or
mental capacities, or lack of experience and knowledge,
unless they have been supervised or instructed in the
use of the product by a person responsible for their
safety. . Children should be supervised to ensure that
they do not play with the product.
If the power cord is damaged, it must be replaced by
persons to avoid any danger.
1-800-433-1626
Fax: 940.325.9311
www.BVC.com
2
Publicidad
Tabla de contenido
