Publicidad
Idiomas disponibles
Idiomas disponibles
CAULKING GUN & SEALING GUN
Operational Precautions
General Safety Instructions
1. Consider work area environment. Do not expose tools to rain. Do not use tools in damp or wet
locations Keep work area clean and well lit. Do not use tools in the present of flammable liquids
or gases.
2. Guard against electric shock. Avoid body contact with earthed or grounded surfaces.
3. Keep children away. Do not let visitors touch the tools or extension cord. All visitors should be
kept away from work area.
4. Store idle tools. When not in use, tool should be stored in a dry locked up place, out of reach of
children.
5. Do not force the tool. It will do the job better and safer at the rate for which it was intended.
6. Stay alert. Watch out what you are doing Use common sense. Do not operate tool when you are
tired. Check damaged parts. Before further use of the tool, a guard or other part is damaged
should be carefully checked to determine that it will operate properly and perform its intended
function.
7. Check for alignment of moving parts, blinding of moving parts, breakage of parts, mounting and
any other condition that may affect its operation.
8. A guard or other parts that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated in this instruction manual. Have defective switches
replaced by an authorized service center. Do not use tool if switch does not turn it on.
9. To ensure the designed operational integrity of power tools, do not remove installed cover or
screws.
10. Use your tool at lower input than specified on the nameplate, otherwise, the finish may be spoiled
and working efficiency reduced by motor overload.
11. Do not wipe plastic parts with solvent. Solvents such as gasoline, thinner, benzene, carbon
tetrachloride, alcohol, ammonia and oil containing chloric annex may damage and crack plastic
parts. Do not wipe them with such solvent. Wipe plastic parts with a soft cloth lightly dampened
with soap water.
12. Dress properly. Do not wear loose clothing or jewelry. Contain long hair keep your hair, clothing,
and gloves away from moving parts.
13. Use safety equipment. Always wear eye protection, non-skid safety shoes, hard hat, or hearing
protection.
14. Do not overreach. Proper footing and balance enables better control of the tool in unexpected
situations.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Art. 8496
Publicidad
