Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Rules
WARNING: Non-observance of the safety rules while working with the hot air tool can
lead to fire, explosion, electric shock or burns. Read the operating instructions before
using the tool and always observe the safely rules. Save these instructions and give
them to persons that have not been instructed before they use the tool.
WARNING: A damaged casing or an opened unit can lead to a hazardous electric
shock. Do not open the unit and do not put a damaged unit into operation. Do not drill
into the casing, e.g. to attach a company label. Before any work on the unit, pull the
mains plug.
WARNING: A damaged power cord can lead to a hazardous electric shock. Check the
power cord regularly. Do not operate the unit when the power cord is damaged.
Always have a damaged cord replaced through a specialist. Do not wrap the cord
around the unit and protect it from oil, heat and sharp edges. Do not carry the unit by
the cord and do not use the cord to pull the plug from the outlet.
WARNING: Do not work in rain or in a moist or wet environment. This can lead to a
hazardous electric shock. Keep the unit dry. Store the unit in a dry location when not in
use. Consider the weather conditions. Do not work in wet sanitary facilities Avoid body
contact with grounded cables or surfaces, such as pipes, radiators, ranges and
refrigerators.
WARNING: Connect power tools that are used in the open via a residual current circuit
breaker (RCCB). If the supply cord is damaged, it must be replaced by manufacturer,
its service agent or similarity qualified persons in order to avoid a hazard.
WARNING: Danger of explosion! The hot air tool can explosively ignite combustible
fluids and gases. Do not work in a potentially explosive environment. Check the
surrounding before starting to work. Do not work on fuels or gas containers or in their
vicinity, even when they are empty.
WARNING: Danger of fire! Heat can reach combustible materials that are hidden
behind coverings, in ceilings, floors or cavities, and ignite them. Inspect the work area
before starting to work and in case of doubt, abstain from using the hot air tool. Do not
point the unit at the same spot for extended periods
WARNING: Danger of fire! An unsupervised operating hot air tool can set fire to
objects that are close by. The unit must be supervised at all limes during operation.
When allowing the switched off unit to cool down, always place it down vertical and
standing. Allow the unit to cool down completely.
WARNING: Danger of fire! When working plastics varnish or similar materials, gases
develop that are easily inflammable and can lead to explosions. Be prepared for
flames to develop and keep suitable fire-extinguishing means at hand.
WARNING: Danger of intoxication! When working plastics, varnish or similar materials,
gases develop that can be aggressive or toxic. Avoid breathing in vapours, even when
they appear to be harmless. Always provide for good ventilation of the work area or
wear a respirator.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
