Descargar Imprimir esta página
Black and Decker GH600 Manual De Instrucciones
Black and Decker GH600 Manual De Instrucciones

Black and Decker GH600 Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

T T
r r
i i
m m
m m
e e
T T
r r
i i
m m
m m
e e
INSTRUCTION MANUAL
Catalog Numbers: GH600, ST7200, ST7201
Date Code:
T
T
HANK
YOU
FOR
CHOOSING
HANK
YOU
FOR
CHOOSING
G
.B
D
G
.B
D
O
O
T
T
O
O
WWW
WWW
LACKAND
LACKAND
T
O
REGISTER
YOUR
T
O
REGISTER
YOUR
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON PLEASE CALL
1-800-544-6986
BEFORE YOU CALL, HAVE THE FOLLOWING INFORMATION AVAILABLE, CATALOG No., TYPE No., AND
DATE CODE . IN MOST CASES, A BLACK & DECKER REPRESENTATIVE CAN RESOLVE THE PROBLEM
OVER THE PHONE. IF YOU HAVE A SUGGESTION OR COMMENT, GIVE US A CALL. YOUR FEEDBACK IS
VITAL TO BLACK & DECKER.
KEY INFORMATION YOU SHOULD KNOW:
• The guard must be installed before trimming or edging - if not, the motor
will overheat.
• When replacing the line, use only .065 in. diameter ROUND line - other-
wise the unit will not function properly.
• Do not bump the feed head against the ground - it will disrupt the feed
mechanism.
• Angle tool slightly (5° to 10°) when trimming.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
VEA EL ESPAÑOL EN LA CONTRAPORTADA.
INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y PÓLIZA DE GARANTÍA.
ADVERTENCIA: LÉASE ESTE INSTRUCTIVO ANTES DE USAR EL PRODUCTO.
Cat. No. GH600, ST7200, ST7201
Form No. 90518528 Rev. 1
Copyright © 2007 Black & Decker
SAFETY GUIDELINES - DEFINITIONS
It is important for you to read and understand this manual. The information it contains relates
to protecting YOUR SAFETY and PREVENTING PROBLEMS. The symbols below are used
to help you recognize this information.
DANGER:
Indicates an imminently hazardous situation which, if not avoided, will result in
death or serious injury.
WARNING:
Indicates a potentially hazardous situation which, if not avoided, could result
in death or serious injury.
CAUTION:
Indicates a potentially hazardous situation which, if not avoided, may result
in minor or moderate injury.
CAUTION:
Used without the safety alert symbol indicates a potentially hazardous situation
which, if not avoided, may result in property damage.
WARNING: IMPORTANT SAFETY WARNINGS AND INSTRUCTIONS
:
WARNING
When using gardening appliances, basic safety precautions should always
be followed to reduce risk of fire, electric shock, and personal injury, including the following.
W
ARNING:
Some dust created by this product contains chemicals known to the State
of California to cause cancer, birth defects or other reproductive harm. Some examples of
these chemicals are:
• compounds in fertilizers
• compounds in insecticides, herbicides and pesticides
• arsenic and chromium from chemically treated lumber
To reduce your exposure to these chemicals, wear approved safety equipment such as dust
masks that are specially designed to filter out microscopic particles.
READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE USING.
• Before any use, be sure everyone using this garden appliance reads and understands all
safety instructions and other information contained in this manual.
• Save these instructions and review frequently prior to use and in instructing
GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL
APPLIANCES
• ALWAYS WEAR EYE PROTECTION – Wear safety spectacles or goggles at all times
when this tool is plugged in.
• GUARD – Do not use this tool without guard attached.
• DRESS PROPERLY – Do not wear loose clothing or jewelry. They can be caught in
moving parts. Rubber gloves and substantial rubber soled footwear are recommended
when working outdoors. Don't operate the tool when barefoot or wearing open sandals.
Wear long pants to protect your legs. Wear protective hair covering to contain long hair.
• NYLON LINE – Keep face, hands and feet clear of rotating nylon line at all times.
• THE ROTATING LINE PERFORMS A CUTTING FUNCTION – Use care when trimming
around screens and desirable plantings.
• KEEP ALL BY-STANDERS AWAY – at a safe distance from work area, especially children.
• IMPORTANT WARNING – When being used as an Edger, stones, pieces of metal and
other objects can be thrown out at high speed by the line. The tool and guard are designed
to reduce the danger. However, the following special precautions should be taken:
• MAKE SURE that other persons and pets are at least 100 feet away.
• TO REDUCE THE RISK of rebound (ricochet) injury, work going away from any nearby
solid object such as wall, steps, large stone, tree, etc. Use great care when working close
to solid objects and where necessary, do edging or trimming by hand.
• AVOID ACCIDENTALLY STARTING – Don't carry plugged-in tool with finger on trigger.
• DO NOT FORCE THE TOOL – at a rate faster than the rate at which it is able to cut
effectively.
All manuals and user guides at all-guides.com
r r
/ /
E E
d d
g g
e e
r r
r r
/ /
E E
d d
g g
e e
r r
B
&
D
!
B
&
D
!
LACK
ECKER
LACK
ECKER
.
/N
O
.
/N
O
ECKER
ECKER
COM
COM
EW
EW
WNER
WNER
.
.
NEW
PRODUCT
NEW
PRODUCT
NOV. '07
Printed in China
others.F
• USE THE RIGHT TOOL – Do not use this tool for any job except that for which it is intended.
• DON'T OVERREACH – Keep proper footing and balance at all times.
• DON'T ABUSE CORD – Don't yank cord from power supply. Keep cord from heat, oil, and
sharp edges.
• DAMAGE TO UNIT – If you strike or become entangled with a foreign object, stop tool imme-
diately, unplug, check for damage and have any damage repaired before further operation is
attempted. Do not operate with a broken hub or spool.
• DAMAGE TO CORD – Keep power cord away from rotating line. If you damage the cord,
unplug it from the power supply before moving the tool or examining the damage. A dam-
aged cord must be replaced before further use.
• DISCONNECT TOOL – when not in use, when replacing line, or prior to cleaning.
• AVOID DANGEROUS ENVIRONMENTAL CONDITIONS – Do not use electric tools in
damp or wet locations. Follow all instructions in this Instruction Manual for proper opera-
tion of your tool. Don't use the tool in the rain.
• DO NOT OPERATE portable electric tools in gaseous or explosive atmospheres. Motors
in these tools normally spark, and the sparks might ignite fumes.
• STORE IDLE TOOLS INDOORS – When not in use, tools should be stored indoors in a
dry, locked-up place out of reach of children.
• GROUND FAULT CIRCUIT INTERRUPTER (GFCI) protection should be provided on the
circuits or outlets to be used for the gardening appliance. Receptacles are available hav-
ing built in GFCI protection and may be used for this measure of protection.
• SECURE EXTENSION CORD using the cord retainer shown in Figure 5.
• STAY ALERT – Watch what you are doing. Use common sense. Do not operate tool when
you are tired.
• MAINTAIN APPLIANCES WITH CARE – Follow instructions in maintenance section.
Inspect extension cords periodically and replace if damaged. Keep handles dry, clean and
free from oil and grease.
• CHECK DAMAGED PARTS – Before further use of the appliance, a guard or other part
that is damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other condition that may affect its operation.
A guard or other part that is damaged should be properly repaired or replaced by an
authorized service center unless otherwise indicated elsewhere in this manual.
WARNING: When servicing double insulated tools, USE ONLY IDENTICAL
REPLACEMENT PARTS. Replace or repair damaged cords.
WARNING: To prevent electrical shock hazard, use only with an extension cord
suitable for outdoor use. Always connect extension cords to a fused line or one protected
by a circuit breaker.
SAFETY WARNINGS AND INSTRUCTIONS: POLARIZED PLUGS
To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider
than the other) and will require the use of a polarized extension cord. The appliance plug
will fit into a polarized extension cord only one way. If the plug does not fit fully into the
extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized
extension cord. A polarized extension cord will require the use of a
polarized wall outlet. This plug will fit into the polarized wall outlet only one way. If the plug
does not fit fully into the wall outlet, reverse the plug. If the plug still does not fit, contact a
qualified electrician to install the proper wall outlet. Do not change the equipment plug,
extension cord receptacle, or extension cord plug in any way.
SAFETY WARNINGS AND INSTRUCTIONS: EXTENSION CORDS
Make sure your extension cord is in good condition. When using an extension cord, be sure
to use one heavy enough to carry the current your product will draw. An undersized cord will
cause a drop in line voltage resulting in loss of power and overheating. The table shows the
correct size to use depending on cord length and nameplate ampere rating. If in doubt, use
the next heavier gauge. The smaller the gauge number, the heavier the cord. If the exten-
sion will be used outside, the cord must be suitable for outdoor work. The letters "WA" on
the cord jacket indicate that the cord is suitable for outdoor use.
Minimum Gage for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
26-50
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
Ampere Rating
More
Not more
American Wire Gage
Than
Than
0
-
6
18
16
6
-
10
18
16
10
-
12
16
16
12
-
16
14
12
1
3
2
4A
5
7
8
51-100
101-150
16
14
14
12
14
12
Not Recommended
1A
4
6
5°-10°
9

Publicidad

loading

Resumen de contenidos para Black and Decker GH600

  • Página 1 Follow all instructions in this Instruction Manual for proper opera- tion of your tool. Don’t use the tool in the rain. Catalog Numbers: GH600, ST7200, ST7201 • DO NOT OPERATE portable electric tools in gaseous or explosive atmospheres. Motors in these tools normally spark, and the sparks might ignite fumes.
  • Página 2 Your trimmer uses .065 in. (1.65 mm) diameter, ROUND nylon line to cut grass and weeds quickly and easily. During use, the tip of the nylon line will become frayed and Modèles GH600, ST7200, ST7201 worn and the special self feeding line hub will automatically feed and trim a fresh length of line.
  • Página 3: Mesures De Sécurité : Fiche Polarisée

    All manuals and user guides at all-guides.com MISE EN GARDE : Utilisé sans le symbole d’alerte à la sécurité, indique une situation du cordon et les mentions de la plaque signalétique de l’outil. En cas de doute, utiliser un potentiellement dangereuse qui, si elle n’est pas évitée, peut résulter en des dommages à la cordon de calibre supérieur.
  • Página 4: Antes De Devolver Este Producto Por Cualquier Motivo, Llame Al

    • INTERRUPTOR DE CIRCUITO PARA FALLAS EN LA TIERRA (GFCI) - Se debe proporcionar protección a los circuitos o clavijas que se usarán con la podadora de setos. Números de catálogo GH600, ST7200, ST7201 Existen contactos con protección GFCI integrada y se pueden utilizar para esta medida de seguridad.
  • Página 5: Advertencias E Instrucciones De Seguridad: Clavijas Polarizadas

    Tenga cuidado de evitar que la línea quede atrapada debajo del carrete. ESPECIFICACIONES 6. Coloque de nuevo la tapa del cubo y encienda la herramienta. En unos pocos segundos usted GH600 120V~ 558W 60Hz 5,0 A escuchará que la línea es cortada automáticamente a la longitud apropiada.

Este manual también es adecuado para:

St7200St7201