Sears Kenmore 110.65212610 Manual De Uso Y Cuidado página 12

If you experience
Cycle time too short
Lint on load
Stains on load or drum
Loads are wrinkled
Odors
Load is too hot
12
TROUBLESHOOTING
Possible Causes
Automatic cycle ending early.
Lint screen clogged.
Dryer fabric softener not properly
used.
The load was not removed from dryer
at the end of the cycle.
Dryer tightly packed.
You have recently been painting,
staining, or varnishing in the area
where your dryer is located.
The electric dryer is being used
for the fi rst time.
Laundry items were removed
from the dryer before the end
of the cycle.
A high temperature cycle was used
or the Dry Temp was set on High.
The load may not be contacting the sensor strips. Level the dryer.
Use Timed Dry for very small loads. Change the dry level
setting on Auto Dry cycles.
Increasing or decreasing the dry level setting will change the
amount of drying time in a cycle.
Lint screen should be cleaned before each load.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your items.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Select Wrinkle Guard™ option to tumble the load without heat
to avoid wrinkling.
Dry smaller loads that can tumble freely, reducing formation
of wrinkles.
If so, ventilate the area. When the odors or fumes are gone from
the area, rewash and dry the clothing.
The new electric heating element may have an odor. The odor
will be gone after the fi rst cycle.
Allow cool down to fi nish before removing laundry from dryer.
All cycles are cooled slowly to reduce wrinkling and make it
easier to handle. Items removed before cool down may feel
very warm.
Select a lower temperature, and use an automatic drying cycle.
These cycles sense the temperature or the moisture level in the
load and shut off when the load reaches the selected dryness.
This reduces overdrying.
Solution