Maintenance And Cleaning - RDM 70007 Instrucciones De Uso

TORQUE ADJUSTMENTS
This relates to the tightening power of your drill/screwdriver and depending on the
application, various levels of driving power are required. Generally the larger the screw
diameter the highter the torque power required to drive the screw until its properly seated.
-1 to 7: for driving small screws
-8 to 19: for driving screws into soft materials or plastics
-Last position (
TIPS
· Always start with the lowest parameter. If the correct parameter has been chosen,
the override clutch will be activated once the screw is flush with the material. When
removing the screws, select a higher parameter. The appropriate adjustments are
best determined after conducting practical tests.
· To drill in the metal: If possible, use the drilling position first to prevent the drill
from escaping.
· Use an adequate coolant. Suitable refrigerants can be obtained from stores.
Always ask for advice on the needs of use.
· The noise of the device can exceed 85dB (A) in the workplace. In this case, wear
hearing protectors.

MAINTENANCE AND CLEANING

Before doing any work on the machine itself, remove the battery packet from it.
Clean the appliance with a moist cloth and a little lubricating soap. Don't use any cleaning
agents or solvents-these could attack the plastic parts of the appliance. Always keep the
surface of the device free from dust and dirt.
): for drilling hard stone
Torque adjustament