Fault Finding Chart; Error Codes - BH BT7050 Manual Del Usuario

FAULT FINDING CHART

PROBLEM
1.The monitor does not
switch on.
2.The monitor switches
on but the motor fails
to start.
3.Walking motion is
jerky on the
treadmill.
4.The machine stops
(the breaker trips).
5.Electrical shocks
through the handrail.
6.The treadmill belt
skews off centre.

ERROR CODES

----
E01/E13
E02
Do not hesitate to get touch with the Technical Assistance Service if you have any
queries by phoning customer services (see last page in manual).
CHECKS
1) Make sure that the
machine is plugged in, the
ON/OFF switch in position 1
and that the safety key is
inserted.
2) Check that the current
limiter is pressed in.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on the
sliding belt.
3.c) Check the tension on the
drive belt.
4) Check that the band is
lubricated.
5) Check that the machine is
plugged into an earthed
mains socket.
6.a) Check that the machine
is level on the floor.
6.b) Check that the machine
does not wobble.
Possible message fault.
Communication failure.
Controller failure.
SOLUTIONS
1) Plug the machine into the
mains supply. Set the switch to
position 1 and insert the safety
key.
2) Switch the machine off and
press the circuit breaker in.
Lubricate the treadmill band.
3.a) Lubricate the sliding belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt tension.
4) Reset the overload button with
the On /Off switch at „0" and
lubricate the treadmill band.
5) Plug the machine into an
earthed mains socket.
Insert the safety key. Check the
connection of the safety key.
Connect the wire well between top
controller and bottom controller.
Replace the controller if necessary.
Check the voltage, the motor and the
motor cable. Replace the controller if
necessary.
12