Read and understand entire manual before assembling or
using hose reel. Failure to follow instructions or warnings
could result in personal injury and/or property damage.
SPECIFICATIONS
Spring driven automatic rewind
with locking ratchet mechanism
(eight locking positions per revolution)
Brass connectors on hose and reel
Air Hose: PVC mesh, Ø12x18 mm, length 15 m
Reel Air Inlet (F): 1/4"
Air Hose Outlet (M): 1/4"
Maximum Pressure: 20 Bar (300 PSI)
Maximum Air Flow: 700 L/min (25 CFM)
IMPORTANT SAFETY RULES
1. Do not exceed 20 Bar (300 PSI) incoming air pressure (from compressor).
2. Wear impact-resistant eye protection in work area at all times.
3. Do not release hose when rewinding. Hold hose end and allow hose to rewind slowly.
4. Never allow children to use hose reel. Keep children clear of work area at all times.
INSTALLING HOSE REEL
Note: Mounting hardware is not included and must be purchased separately
Decide first where reel will be mounted before purchasing hardware.
Different mounting positions require different types of hardware.
Reel can be mounted on the floor, ceiling, or wall, wherever it is convenient. When choosing a
location, remember that you can ally mount reel to a load-bearing structural member capable of
supporting combined weight of reel, hose, and forces caused by pulling or maneuvering hose.
Generally, mounting reel near air compressor is best since you can connect the two with a shorter,
less expensive length of hose. Also, air compressor controls will be nearby for convenient adjusting.
Once you have located a mounting spot, consult the "TYPICAL MOUNTING POSITIONS" chart below
and choose the diagram that most closely matches your mounting position. If necessary, adjust guide
arm position to match diagram.
TYPICAL MOUNTING POSITIONS
Wall
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Retractable Air Hose Reel
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Floor
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 8584
Ceiling