Coffee Preparation; Other Functions - TEFAL FCM SENSE CM693 Manual Del Usuario

COFFEE PREPARATION

• Lift the coffee maker's lid (b). Fig. 3.
• Fill the carafe (g) with cold or warm water. Pour water in the water tank
(c) Fig. 4.
• The number of cups is indicated by marks on the carafe and by the
water level indicator. Do not exceed 10-15 cups. Fig. 5.
• Place the carafe (g) with its lid (e)closed on the heated base (h) by
ensuring that it is properly in place in order to activate the mechanism
that allows the coffee to flow. Fig. 8.
• Make sure that the filter holder (i) is inserted. Fig. 6. Place the filter
paper into the filter holder (i). Make sure that the filter paper is fully
open and properly in place in the filter holder. Fig. 7.
• Should some ground coffee be inadvertently poured into the reservoir,
refrain from starting the cycle and first clean the reservoir.
The ground coffee could otherwise block the water circuit.
• Add 1 spoonful (P) of ground coffee per cup. Do not exceed 10 spoonfuls
(70 g). Fig. 9.
• Close the lid (b).
If the coffee maker is in standby, press any button to switch it on.
• Press the ON/OFF (J) button to start the cycle. The coffee maker beeps
and the carafe symbol is displayed on the screen. Fig. 10.
• When the cycle is complete, the warm-up feature automatically turns
on for 30 minutes. The carafe symbol remains on the display for the
duration of the warm-up period.
• To stop the coffee maker during the cycle, press the ON/OFF button (J).
Please note:
• The quantity of coffee in the carafe at the end of the cycle is less than
the quantity of water poured into the reservoir, since the ground coffee
and the filter absorb approximately 10% of it.
• The reservoir is equipped with an overflow opening at the back of the
appliance. If you add too much water, it will come out of this opening.
10

OTHER FUNCTIONS

– DELAYED START (PROG)
Setting the time of the Delayed Start
• Your appliance features a delayed start program.
• Make sure that the clock is set to the correct time. If this is not the case,
follow the instructions in the section PROGRAMMING THE CLOCK.
• Press the PROG button (K) to set the automatic start time. The PROG
icon will appear on the display. Fig. 11.
• Set the time by pressing the HR button (L) for the hours and MIN
(M) button for the minutes. Fig. 12. The time setting is automatically
confirmed after approximately 5 seconds or by pressing the PROG (K)
button. Fig. 13.
• Your coffee maker will start automatically at the programmed time.
You can view the programmed time at any time by pressing the PROG
button (K).
• To cancel the delayed start, hold down the PROG (K) button for 5
seconds.
– PRE-INFUSION MODE - AROMA FUNCTION
Please note: The AROMA function gets the most from the coffee flavours
thanks to the grind pre-infusion phase.
• Press the AROMA (N) button before starting the coffee cycle to start the
PRE-INFUSION mode.
• The AROMA indicator light turns on. Fig. 14.
• To cancel the PRE-INFUSION mode, press the AROMA (N) button again.
EN
11