Maintenance - CEVIK PRO PE903XL Manual De Instrucciones

EN
TABLE 1 . RECOMMENDED SHADE NUMBER ACCORDING TO STANDARD EN 169:2002
Adopt greater or smaller shade number pursuant to the field condition.

MAINTENANCE.

1. Unlock the pressure plate pressure seal if it is blocked (A). Press the joint to the protection
plate and remove it (A).
2. Replace the protection plate and insert the snap joint, then lock it (B).
3. Turn the wheel (C) clockwise to release and open the frame, remove the filter assembly
from the housing and replace it (D).
4. Pull out the inner cover plate (E). Remove the protective film. Replace the inner
protection plate (E).
5. Use a tool such as long nose pliers to remove the covers of the three selectors (B, C, and
D) on the adjustment panel. Use a screwdriver to remove the covers of the small switches
(E and F). Remove the trim panel cover from the housing.
6. Set the adjustment panel cover back and tighten the five screws. Rotate the three selector
shafts counterclockwise to the maximum position, place each selector cover on the axis
related to the arrow pointing in the maximum direction. Move the switch to the side,
reposition the cover accurately. Be very careful, otherwise it is easy to break the inside of
the switch (G).
7. Pull down on the battery covers to remove them (H). Replace the CR2450 lithium
batteries, positive + up (I). Reinstall the battery covers (H).
21