Parts Breakdown; Parts List - Matco Tools SK12PR Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

- Make sure the exhaust vent is facing upward.
- Do not use any soldering iron if damage is visible.
- Close the taps of the soldering iron before connecting the gas cylinder.
- Gas soldering iron should only be used for up to 5 minutes before pausing and allowing the unit to cool down.
REMINDER
- The soldering iron shall be used away from flammable materials such as wooden tables.
- The soldering iron must be operated on a horizontal surface.
- Butane shall be filled in a well-ventilated location, preferably outside, away from any sources of ignition,
such as naked flame, pilots, sparks and away from other people.
- If there is a leak on your soldering iron (smell of gas), take it outside immediately into a well-ventilated flame
free location where the leak maybe detected and stopped. If you wish to check for leaks on your soldering iron,
do it outside. Do not try to detect leaks using a flame, use soapy water.
- Do not leave the soldering iron unattended.
- It is strongly suggested to use this product together with an independent Iron stand to avoid
any heating hazard when on standby.

PARTS BREAKDOWN

11
Index
Part No.
1
SK12PR01
2
SK8MAT08
3
SK8MAT07
4
SK8MAT02
5
SK8MAT03
6
SK8MAT05
INDEXING PENCIL & RIGHT
ANGLE BUTANE SOLDERING KIT
9
10
8
7

Parts List

Description
Main Body
Lead-Free Solder
Sponge W/Tray
Chisel Soldering Tip
Anvil Soldering Tip
Angle Knife Soldering Tip
3
6
5
4
Index
Part No.
7
SK8MAT04
8
MTKMAT04
9
SK8MAT06
10
SK12PR02
11
SK12PR03
Page 4
SK12PR
1
2
Description
Needle Soldering Tip
Sharp Knife Tip
Heat Shrink Deflector
Cap
Magnetic Stand
011
2011254-14

Publicidad

Tabla de contenido
loading

Tabla de contenido