Duronic GHS48 Manual De Instrucciones página 8

1. When the power adapter is plugged into the grow light system and
switched on at the mains socket, the system will sound a long "beep" to
indicate it is ready to work.
2. After the machine runs for several days, the water level in the tank
will naturally fall. When the water level is no longer sufficient for the plants
to grow, the machine will sound a long "beep" to let you know. If this
happens, please refill the tank to the correct amount. Once you have done
this the alarm will automatically stop beeping.
3. When the system is working normally with the light on, a shorter
"beep" will sound when you press any button. If the mode is being
changed, the light brightness will correspond accordingly.
4. If a button on the panel is pressed when the machine is turn on and
the light is off, the machine will make a short "beep" sound. If it does not
make a beep when a button is pressed, it is likely that the system is not
switched on properly. If this occurs, try the following:
• Check if the machine is connected to the mains power supply.
• If the machine is connected to power but in a dormant standby state,
press the power button to test it. When the power button is pressed
in the dormant state, the light will go off after 3 blinks.
Key Prompts and What They Mean
Hydroponic System Components
Control panel
LED light assembly
Left side plate
Right side plate
Plant basket container
Top tank cover
Water tank
Base plate
Feet
Pump jack
8