Model Differentiation; Unit Setup - Toshiba RBC-RD1-PE Instrucciones De Instalación

Ocultar thumbs Ver también para RBC-RD1-PE:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 37
All manuals and user guides at all-guides.com
K7046 Combined Installation

Model Differentiation

G
There are two models available, the first is RBC-RD1-PE. The RD1 is designed to be
installed next to the indoor unit, with the remote sensor and audible alarm located at
a low level and preferably under the indoor unit.
G
The RD1 is designed for use with MMS indoor units and RAV '4' Series AI indoor
units only.
G
The second model is the RBC-RD2-PE. The (RD2) is designed for use in the modular
multi outdoor unit. The unit will be located within the compressor housing, and it has
an internal sensor.
G
The RD2 can only be fitted to the MMS outdoor unit.
G
The functionality of both systems will be covered in indoor & outdoor operation
section of this manual.
G
There are two control PCB's inside the leak detector, each with jumpers which enable
specific functions to be enabled/disabled. The diagrams below show the locations of
these jumpers.
+ sig – mute + buzzer
6/3/01
8:37 am
Page 6
GB

Unit Setup

AI
ALARM
N
L
control board
A B C
JP
Sub PCB
6

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rbc-rd2-pe

Tabla de contenido