Hair Straightener - Magic MGC HS 4 Manual De Instrucciones

Fax +32 2 359 95 50

SPECIAL ATTENTION
Your new appliance is designed with a protective coating around the heating coils. When
plugged in and operating for the first time, there may be a little momentary smoking while this
coating is initially heated. This presents no danger to the user and does not indicate a defect in
the unit. When using for the first time, allow the appliance to continue running until the smoke
dissipates. This should last only about 30 seconds.
General use of the appliance
Before using the appliance, untangle your hair with a comb or a brush.
Use the appliance on dry or slightly wet hair, never use it on too wet, synthetic hair or wigs.
For a better result, use the appliance on clean, dry and untangled hair.
WARNING
 The ceramic plates and the metallic parts become very hot during use. Do not touch these
parts and avoid contact with skins. Always stand your appliance on its base.
 If you have thin or fragile hair, too hot a temperature could damage or even burn them

HAIR STRAIGHTENER

 Plug in the appliance and put the switch of the base on "1".
 Place the hair straightener on the charging base. The appliance heats automatically
once it is placed on the base and the switch is on "1".
 The pilot light of the charging base and the pilot light of the hair straightener turn on to
indicate that the appliance is heating. Let it heat for about 5 minutes before you use it.
 Position the hair straightener as closely as possible to the roots and take a section 2 to 3
cm wide.
 Slowly glide the hair straightener from the roots to the ends. When you get to the ends,
turn the hair straightener in a half-circle inward (or outward).
 Hold the hair straightener for 2 to 3 seconds and release.
 Repeat this process several times if necessary in order to obtain an optimal result.
 To give more volume to your hair, use an upward motion to lift the roots from the scalp
when the appliance is close to the roots, i.e. at the beginning of the straightening process.
 For a better use, you should place the appliance to heat on its base approximately every
four minutes and let it heat 1 to 2 minutes every time.
HAIR CURLER
 Plug in the appliance and put the switch of the base on "1".
 Put the ON/OFF switch on ON.
 Place the hair curler on the charging base.
 The pilot light of the base and the pilot light of the hair curler turn on to indicate that the
appliance is heating. Let it heat for about 5 minutes before you use it.
 Take a tuft. Open the hair curler pressing on its lever and hold the tuft tight in the curler.
Loosen the lever and slide the curler to the end of the tuft. Then roll the tuft around the
curler in the desired direction.
 Open the curler after 5 to 10 seconds and remove it.
 For a better use, you should place the appliance to heat on its base approximately every
four minutes and let it heat 1 to 2 minutes every time.
All manuals and user guides at all-guides.com
Copies of the I/B. Please reproduce them without any
changes except
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
8
Assembly page 8/32
under special instruction
MGC HS 4 - 070321
from Team