Installing/Removing Battery Pack; Adjustable Head - Ryobi PCL631 Manual Del Operador

INSTALLING/REMOVING BATTERY PACK

See Figure 1, page 8
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
WARNING:
Always remove battery pack or unplug extension cord
from your product when you are assembling parts, mak-
ing adjustments, cleaning, or when not in use. Removing
battery pack or unplugging extension cord will prevent
accidental starting that could cause serious personal
injury.
INSTALLING/REMOVING POWER CORD
See Figure 2, page 8.
WARNING:
Do not route cord under carpets, rugs, runners, furniture,
or appliances and always route cord away from traffic
areas to prevent a tripping hazard.
 Insert the female end of the power cord into the product
as shown.
 Connect the male end of the power cord to the power
source. Make sure the power cord is seated securely
before beginning operation.
 To remove the power cord, disconnect the cord from the
power source and then from the rear of the light.
POWER BUTTON (HIGH/MEDIUM/LOW/OFF)
See Figure 3, page 8.
The work light will be in the OFF position until the power
button is pressed.
 C onnect the product to the battery pack.
 P ress and release the button to cycle between HIGH,
MEDIUM, LOW, and OFF.
 P ress and hold the button for two seconds while ON (in
any mode) and the light will shut off.
 P ress and hold the button for two seconds while OFF
allows the light to go into low mode.
NOTE: This light is equipped with a low voltage indicator. If
the light flashes 3 times while a battery pack is installed, this
indicates a low charge condition. Install a charged battery
pack and resume operation.
OPERATION
WARNING:
Keep work light away from combustible materials. If
wrapped or in contact with fabrics, the work light lens
can produce sufficient heat to melt some fabrics. To avoid
serious personal injury, never allow the work light lens to
come in contact with anything.
OPERATING THE PANEL LIGHT
See Figure 4, page 9.
WARNING:
Hybrid tools are always in operating condition. Therefore,
unit should always be in the OFF status, with the battery
pack removed and power cord disconnected, when not
in use. Do not leave light on while unattended. Failure to
follow these instructions could result in serious personal
injury.
 Install battery pack or connect product to an AC power
supply.
 Press the power button to turn panel light on and off.
 Place the light's adjustable panels in the positions
needed to direct light as desired.
WARNING:
Keep panel light away from combustible materials. If
wrapped or in contact with fabrics, the panel light lens
can produce sufficient heat to melt some fabrics. To avoid
serious personal injury, never allow the panel light lens to
come in contact with anything.

ADJUSTABLE HEAD

See Figure 5, page 9.
CAUTION:
Do not place hands or fingers between adjustable head
and frame when positioning panel light to avoid pinching
your fingers or hands.
In addition to adjusting the individual LED panels of the
light, the adjustable head can also be set in a variety of
positions. To adjust positions:
 Adjust head to desired position.
 The hinge of the light head has adequate tension to hold
the adjustable head in position. Over time, the hinge could
lose tension causing the head to droop or sag. If the light
head stops holding its position, tighten the exposed hex
bolts as needed.
6 – English