Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Attach fasteners to hoodshield by inserting screw
through hood shield, and into well nut. Partially
thread screw into well nut.
Center part on front edge of hood and align holes.
Peel back 2 " (5 cm) of tape liner off both tape strips to expose
adhesive. Fold free ends over so they will be accessible.
NOTE: Observe the alignment from the side view in order to guide
With the fastener assembly inserted into hole in hood,
the hood shield with its attached fastener into the proper hole in the
secure hood shield to hood by tightening screw to ex
hood.
pand well nut. Repeat for remaining fasteners.
Close Hood.
Remove remaining tape liner by pulling on free ends,
and apply pressure to adhere tape.
Page 2 of 3
Publicidad
Tabla de contenido
