Connection; Connecting The Vga Input; Connecting The Touch Module - BenQ RP654K Manual Del Usuario

14

Connection

Connection

Connecting the VGA input

1. Connect the VGA IN jack on the display to the VGA output jack on a computer
using a D-Sub (15-pin) cable.
2. Connect the computer's audio output jack to the AUDIO IN jack on the display
with a suitable audio cable.
3. To view images from this input, press the INPUT button on the remote control to
switch to respective input source.

Connecting the touch module

Connect the TOUCH (type B) jack on the display to the USB port of a computer using
the supplied USB cable. The touch module of the display supports easy Plug-and-Play
operation. There is no need to install additional drivers on the computer.
• Avoid blocking the touch screen frame (where sensors are located) when initiating the touch
module.
• It is highly recommended that you connect the display to the PC or laptop directly. Avoid
connecting the display to a face plate device which may cause failures in touch operations.
• If any ghost image occurs, please try to un-plug and then re-plug all USB cables. If the failure
image still exists, use another USB type B to A cable.
• TOUCH 2 port must be connected with HDMI 3, DP, or VGA IN.
Audio
DP
HDMI
cable
cable
cable
USB cable
D-Sub (15-pin)
cable
Computer