Panasonic EY7202 Manual De Instrucciones página 11

Destornillador de impacto inalambrico
Ocultar thumbs Ver también para EY7202:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 55
2) Tightening time
Longer tightening time results in increased
tightening torque. Excessive tightening,
however, adds no value and reduces the
life of the tool.
3) Different bolt diameters
The size of the bolt diameter affects the
tightening torque.
Generally, as the bolt diameter increases,
tightening torque rises.
4) Tightening conditions
Tightening torque will vary, even with the
same bolt, according to grade, length, and
torque coefficient (the fixed coefficient indi-
cated by the manufacturer upon production).
VII.
ACCESSORIES
Use only bits suitable for size of chuck.
VIII.
APPENDIX
MAXIMUM RECOMMENDED CAPACITIES
Model
Wood screw
Screw
driving
Self-drilling screw
Bolt fastening
GUIDELINE TABLE
Fixing material
Base material
(thickness)
2 4" Material
2 4" Material
Plywood
2 4" Material
12 mm (1/2")
Gypsum board
2 4" Material
12 mm (1/2")
SPC
SPC
1.2 mm (1/16")
1.2 mm (1/16")
2 4" Material
2 4" Material
NOTE:
• When screwing TEKS screws into hard materials, use the lighter digital clutch's setting to
avoid slippage which may chip or damage the screw. For the final tightening, use the one-
shot impact function.
• Depending on the type of screw or the hardness of the material, the screw may not be com-
pletely flush with the surface. When working with cabinet boards or other more decorative
materials where screws need to sit flush on the surface, use the lighter digital clutch's setting
to avoid damaging the material, and then finish using the one-shot impact function.
All manuals and user guides at all-guides.com
5) Socket play
6) Switch (Variable speed control trigger)
7) Effect of Connecting Adaptor
Screw
(Size)
Drywall screw
4.2 75
(3/16" 3")
Drywall screw
3.8 28
(1/8" 1-1/4")
Drywall screw
3.8 28
(1/8" 1-1/4")
Self-drilling screw
4 1.3
(3/16" 1/2")
Coach screw
9 50
(3/8" 1-15/16")
- 11 -
Tightening torque will vary , even with
the same bolting material (e.g. steel),
according to the surface finish.
Torque is greatly reduced when the bolt
and nut start turning together.
Torque is lowered as the six-sided configu-
ration of the socket of the wrong size is
used to tighten a bolt.
Torque is lowered if the unit is used with
the switch not fully pulled out.
The tightening torque will be lowered
through the use of a universal joint or a
connecting adaptor.
EY7202
3.5 -
9.5 mm (1/8" - 3/8")
3.5 -
6 mm (1/8" - 1/4")
Standard bolt : M6 - M12
High tensile bolt : M6 - M10
Impact
power
Clutch setting stage reference
mode
H M S
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Publicidad

Tabla de contenido
loading

Tabla de contenido