Imetec INTELLIVAPOR EXPERT IM 2500 Instrucciones Para El Uso página 18

Problem
EN
The appliance does
not go on.
The plate
temperature LED
(10) goes on and off.
Smoke comes out of
the appliance when it
is switched on for the
first time.
Impurities come out
of the plate of the
new iron.
The appliance does
not produce steam.
Water leaks from the
plate (8).
After ironing, steam
comes out of the
boiler safety cap (1).
16
Possible cause
The household appliance is
not on
Normal procedure.
This is absolutely normal and
is due to the expansion of the
plastic material.
This is perfectly normal in a
new iron.
The appliance is not on.
The steam button (9) is not
being pressed.
The water in the boiler has
finished and the no water
LED (3) is on.
The impurities or chemical
substances found in the
water have deposited on the
plate.
The boiler safety cap (1)
may have not been closed
correctly or water may have
leaked while being topped-up.
Solution
Verify that the appliance is connected
correctly to the power cord and the ON/
OFF button (4) is pressed.
The plate temperature LED (10) goes
on and off intermittently while ironing,
indicating that the appliance maintains the
optimal temperature.
This no longer occurs after a while.
These particles are completely harmless
and will disappear after the iron is used a
few times.
Press the ON/OFF button (4).
Keep the steam button (9) pressed as you
iron.
Fill the boiler (see chapter Filling the boiler
when hot).
Wait for the plate to cool down and clean it
with a damp cloth.
Switch the appliance OFF and let it cool
down. Remove the boiler safety cap (1),
dry the water around the top-up opening
and tighten the cap. The appliance can
then be switched back on.